Претраживање
Приказ резултата 1-10 од 899
Effect of material heterogeneity and constraint conditions on ductile fracture resistance of welded joint zones - Micromechanical assessment
(Pergamon-Elsevier Science Ltd, Oxford, 2017)
The topic of this work is assessment of ductile fracture initiation and development in different zones of welded joint of a high strength low alloyed (HSLA) steel. A combined experimental-numerical procedure is applied for ...
Morphology, internal structure and growth mechanism of electrodeposited Ni and Co powders
(Springer, New York, 2006)
In this paper the morphology (SEM analysis), the internal structure (cross-section analysis) and the growth mechanism of Ni and Co powders electrodeposited from ammoniacal electrolyte are investigated. It is shown that ...
A two-stage metal valorisation process from electric arc furnace dust (eafd)
(Croatian Metallurgical Soc, Zagreb, 2016)
This paper demonstrates possibility of separate zinc and lead recovery from coal composite pellets, composed of EAFD with other synergetic iron-bearing wastes and by-products (mill scale, pyrite-cinder, magnetite concentrate), ...
Magneli phase titanium oxides as catalyst support - Electrochemical behavior of Ebonex/Pt catalysts
(Journal of New Materials for Electrochemical Systems, 2006)
The impregnation method has been applied to synthesize platinum nanoparticles on Magneli phase titanium oxide powder (Ebonex). Surface area of the Ebonex support was determined by BET technique. Distribution and morphology ...
An intensity based optical fibre sensor for flexural damage detection in woven composites
(Sage Publications Ltd, London, 1999)
Flexural deformation of the composite laminate and the integrity of the embedded optical fibres under three-point bending load were monitored. Signal attenuation in optical fibres was used as the damage indicator. The ...
Hydrometallurgical recovery of tin and lead from waste printed circuit boards (wpcbs): limitations and opportunities
(Croatian Metallurgical Soc, Zagreb, 2016)
In this paper, possibility for selective Pb and Sn recovery, using three different solutions of NaOH, HCl and HNO3, from WPCBs containing low concentrations of Pb and Sn is presented. According to obtained results, over ...
Experimental and numerical thermo - mechanical analysis of friction stir welding of high - strength alluminium alloy
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
This paper presents experimental and numerical analysis of the change of temperature and force in the vertical direction during the friction stir welding of high-strength aluminium alloy 2024 T3. This procedure confirmed ...
Mathematical modeling of cross-linking monomer elution from resin-based dental composites
(Wiley-Blackwell, Hoboken, 2013)
Elution of potentially toxic substances, including monomers, from resin-based dental composites may affect the biocompatibility of these materials in clinical conditions. In addition to the amounts of eluted monomers, ...
Mechanochemical synthesis of gamma-Bi2O3
(Amsterdam : Elsevier, 2004)
A series of gamma-Bi2O3 phases doped with Zn, Si, Pb and Fe was prepared by mechanochemical treatment of corresponding oxide mixtures with a nominal composition 6Bi(2)O(3) (.) MOx (MOx = ZnO, SiO2, PbO) and 12Bi(2)O(3) (.) ...
Predicting liquid chromatography−electrospray ionization/mass spectrometry signal from the structure of model compounds and experimental factors; case study of aripiprazole and its impurities
(Elsevier B.V., 2023)
A priori estimation of analyte response is crucial for the efficient development of liquid chromatography–electrospray ionization/mass spectrometry (LC–ESI/MS) methods, but remains a demanding task given the lack of knowledge ...