Претраживање
Приказ резултата 1-10 од 691
Effect of material heterogeneity and constraint conditions on ductile fracture resistance of welded joint zones - Micromechanical assessment
(Pergamon-Elsevier Science Ltd, Oxford, 2017)
The topic of this work is assessment of ductile fracture initiation and development in different zones of welded joint of a high strength low alloyed (HSLA) steel. A combined experimental-numerical procedure is applied for ...
Morphology, internal structure and growth mechanism of electrodeposited Ni and Co powders
(Springer, New York, 2006)
In this paper the morphology (SEM analysis), the internal structure (cross-section analysis) and the growth mechanism of Ni and Co powders electrodeposited from ammoniacal electrolyte are investigated. It is shown that ...
Kinetic analysis of hydrogen evolution at Ni-Mo alloy electrodes
(Elsevier Science Ltd, 2000)
The hydrogen evolution reaction (HER) on Ni, Mo and MoNi intermetallic compound was investigated with ac impedance and dc polarization measurements in 1.0 mol dm-3 NaOH solution at 25 °C. The rate constants of the forward ...
Influence of structural changes induced by oxidation and addition of silver ions on electrical properties of cotton yarn
(Editura Acad Romane, Bucuresti, 2014)
This paper is focused on investigating the electrical behavior of cotton yarn oxidized with nonselective oxidation agent, hydrogen peroxide, through measurement of structural changes in cotton, and elucidating the influence ...
Magneli phase titanium oxides as catalyst support - Electrochemical behavior of Ebonex/Pt catalysts
(Journal of New Materials for Electrochemical Systems, 2006)
The impregnation method has been applied to synthesize platinum nanoparticles on Magneli phase titanium oxide powder (Ebonex). Surface area of the Ebonex support was determined by BET technique. Distribution and morphology ...
An intensity based optical fibre sensor for flexural damage detection in woven composites
(Sage Publications Ltd, London, 1999)
Flexural deformation of the composite laminate and the integrity of the embedded optical fibres under three-point bending load were monitored. Signal attenuation in optical fibres was used as the damage indicator. The ...
Mathematical modeling of cross-linking monomer elution from resin-based dental composites
(Wiley-Blackwell, Hoboken, 2013)
Elution of potentially toxic substances, including monomers, from resin-based dental composites may affect the biocompatibility of these materials in clinical conditions. In addition to the amounts of eluted monomers, ...
Mechanochemical synthesis of gamma-Bi2O3
(Amsterdam : Elsevier, 2004)
A series of gamma-Bi2O3 phases doped with Zn, Si, Pb and Fe was prepared by mechanochemical treatment of corresponding oxide mixtures with a nominal composition 6Bi(2)O(3) (.) MOx (MOx = ZnO, SiO2, PbO) and 12Bi(2)O(3) (.) ...
Predicting liquid chromatography−electrospray ionization/mass spectrometry signal from the structure of model compounds and experimental factors; case study of aripiprazole and its impurities
(Elsevier B.V., 2023)
A priori estimation of analyte response is crucial for the efficient development of liquid chromatography–electrospray ionization/mass spectrometry (LC–ESI/MS) methods, but remains a demanding task given the lack of knowledge ...
Selective Antimicrobial Performance of Biosynthesized Silver Nanoparticles by Horsetail Extract Against E. coli
(Springer, Dordrecht, 2020)
The aim of this study was the development of a non-toxic, biosynthetic antimicrobial agent which selectively acts on only one type of microorganism, and preserves the microbiota. Antimicrobial performance of biosynthesized ...