Pretraživanje
Prikaz rezultata 1-10 od 892
Effect of material heterogeneity and constraint conditions on ductile fracture resistance of welded joint zones - Micromechanical assessment
(Pergamon-Elsevier Science Ltd, Oxford, 2017)
The topic of this work is assessment of ductile fracture initiation and development in different zones of welded joint of a high strength low alloyed (HSLA) steel. A combined experimental-numerical procedure is applied for ...
Morphology, internal structure and growth mechanism of electrodeposited Ni and Co powders
(Springer, New York, 2006)
In this paper the morphology (SEM analysis), the internal structure (cross-section analysis) and the growth mechanism of Ni and Co powders electrodeposited from ammoniacal electrolyte are investigated. It is shown that ...
Kinetic analysis of hydrogen evolution at Ni-Mo alloy electrodes
(Elsevier Science Ltd, 2000)
The hydrogen evolution reaction (HER) on Ni, Mo and MoNi intermetallic compound was investigated with ac impedance and dc polarization measurements in 1.0 mol dm-3 NaOH solution at 25 °C. The rate constants of the forward ...
Use of chènevotte, a valuable co-product of industrial hemp fiber, as adsorbent for pollutant removal. Part i: Chemical, microscopic, spectroscopic and thermogravimetric characterization of raw and modified samples
(MDPI AG, 2021)
FINEAU (2021–2024) is a trans-disciplinary research project involving French, Serbian, Italian, Portuguese and Romanian colleagues, a French agricultural cooperative and two surface-treatment industries, intending to propose ...
Heat generation during plunge stage in friction stir welding
(Vinca Institute of Nuclear Sciences, 2013)
This paper deals with the heat generation in the Al alloy Al2024-T3 plate under different rotating speeds and plunge speeds during the plunge stage of friction stir welding. A 3-D finite element model is developed in the ...
Influence of structural changes induced by oxidation and addition of silver ions on electrical properties of cotton yarn
(Editura Acad Romane, Bucuresti, 2014)
This paper is focused on investigating the electrical behavior of cotton yarn oxidized with nonselective oxidation agent, hydrogen peroxide, through measurement of structural changes in cotton, and elucidating the influence ...
A two-stage metal valorisation process from electric arc furnace dust (eafd)
(Croatian Metallurgical Soc, Zagreb, 2016)
This paper demonstrates possibility of separate zinc and lead recovery from coal composite pellets, composed of EAFD with other synergetic iron-bearing wastes and by-products (mill scale, pyrite-cinder, magnetite concentrate), ...
Magneli phase titanium oxides as catalyst support - Electrochemical behavior of Ebonex/Pt catalysts
(Journal of New Materials for Electrochemical Systems, 2006)
The impregnation method has been applied to synthesize platinum nanoparticles on Magneli phase titanium oxide powder (Ebonex). Surface area of the Ebonex support was determined by BET technique. Distribution and morphology ...
An intensity based optical fibre sensor for flexural damage detection in woven composites
(Sage Publications Ltd, London, 1999)
Flexural deformation of the composite laminate and the integrity of the embedded optical fibres under three-point bending load were monitored. Signal attenuation in optical fibres was used as the damage indicator. The ...
Hydrometallurgical recovery of tin and lead from waste printed circuit boards (wpcbs): limitations and opportunities
(Croatian Metallurgical Soc, Zagreb, 2016)
In this paper, possibility for selective Pb and Sn recovery, using three different solutions of NaOH, HCl and HNO3, from WPCBs containing low concentrations of Pb and Sn is presented. According to obtained results, over ...