Претраживање
Приказ резултата 1-10 од 46
Prediction and fuzzy synthetic optimization of process parameters in heavy clay brick production
(Elsevier Sci Ltd, Oxford, 2013)
Many factors influence final clay brick properties, since the raw materials used are highly heterogeneous. Statistical analysis is rarely used, according to literature, but it would improve understanding of the overall ...
Optimization of the production process through response surface method: Bricks made of loess
(Elsevier, 2013)
Loess clays are commonly used to produce bricks. Heavy clays, taken at location near Zrenjanin, Serbia, are used as a representative raw material in this study. The sample, containing about 28% of clay sized particles, is ...
Cyclic oxidation of Ti3Al-based materials
(Ceramics International, 2019)
The microstructure variation and oxidation behavior of a hot-rolled and quenched Ti-24Al-11Nb (at%) intermetallic alloy with and without protective Ni-20Cr (at%) coating were studied in the air at a cyclic annealing ...
Synthesis and characterization of Cr3+ doped TiO2 nanometric powders
(Elsevier, 2016)
Simple route was used for synthesis of nanostructured titania samples doped with 3 and 6 mol% of Cr3+ Titanium(IV)-isopropoxide and water were used as starting materials and as an agents for controlling hydrolysis and ...
Sensitivity analysis of mathematical models for final product properties: Link to DTG curve
(Elsevier Sci Ltd, Oxford, 2013)
Compressive strength and water absorption of fired heavy clay products varies with firing temperatures, but not entirely according to linear function, as it is mostly reported in literature. Also, differential thermo-gravimetric ...
Physical-mechanical and microstructural properties of alkali-activated fly ash-blast furnace slag blends
(Elsevier Sci Ltd, Oxford, 2015)
This paper investigated physical mechanical and microstructural properties of alkali-activated binders based on blends of fly ash (FA) and blast furnace slag (BFS). FA BFS blends were alkali-activated with sodium silicate ...
Highly ordered macroporous gamma-alumina prepared by a modified sol-gel method with a PMMA microsphere template for enhanced Pb2+, Ni2+ and Cd2+ removal
(Elsevier Sci Ltd, Oxford, 2017)
The adsorption performance of three-dimensionally ordered macroporous (3DOM) gamma-alumina was investigated for enhanced Pb2+, Ni2+ and Cd2+ removal. The synthesis was based on a modified sol-gel method using a colloidal ...
Ex-situ sensitization of ordered TiO2 nanotubes with CdS quantum dots
(Elsevier Sci Ltd, Oxford, 2015)
Ordered titania nanotubes (pore diameter approximate to 90 nm and wall thickness approximate to 10 nm) were obtained by the anodization technique and used for the ex-situ deposition of cadmium sulfide quantum dots (CdS ...
Lead immobilization by geopolymers based on mechanically activated fly ash
(Elsevier Sci Ltd, Oxford, 2014)
In this paper, the effectiveness of geopolymers based on initial and mechanically activated fly ash in immobilization of lead was investigated. Fly ash (FA) was firstly mechanically and then alkali activated at room ...
Preparation of low cost alumina nanofibers via electrospinning of aluminium chloride hydroxide/poly (vinyl alcohol) solution
(Elsevier Sci Ltd, Oxford, 2013)
Alumina nanofibers are very suitable materials for use as reinforcement in a great variety of high performance composite materials. Nanosized alumina fibers were prepared from the aluminum chloride hydroxide/poly (vinyl ...