Претраживање
Приказ резултата 31-40 од 46
Spherical assemblies of titania nanotubes generated through aerosol processing
(Elsevier Sci Ltd, Oxford, 2015)
We report on the possibility to build hierarchically organized three-dimensional (3D) titania spherical particles having high surface-to-volume-ratio, by aerosol processing of nanotubular building blocks. Morphology and ...
Dry-pressed anodized titania nanotube/CH3NH3PbI3 single crystal heterojunctions: The beneficial role of N doping
(Elsevier Sci Ltd, Oxford, 2019)
Highly ordered, anodically grown TiO2 nanotubes on titanium supports were annealed in ammonia atmosphere in order to incorporate nitrogen doping ( lt = 2 at.%) in the titanium oxide lattice. FESEM micrographs revealed ...
Optimized preparation of alumina based fillers for tuning composite properties
(Elsevier Sci Ltd, Oxford, 2018)
Alumina based particles were prepared from aluminium chloride hydroxide as starting material by sol-gel technique. One series of particles was doped with ferrous oxide. Both series of particles were calcinated at three ...
Mg/Cu co-substituted hydroxyapatite - Biocompatibility, mechanical properties and antimicrobial activity
(Elsevier Sci Ltd, Oxford, 2019)
The aim of this study was to improve the mechanical properties and to optimize antimicrobial activity of hydroxyapatite (HAP) by simultaneous doping with Mg and Cu ions in order to obtain material that would be able to ...
Bioactive glass-ceramics prepared by powder sintering and crystallization of polyphosphate glass containing strontium
(Elsevier Sci Ltd, Oxford, 2017)
Melt-quenching method was employed for obtaining a glass-ceramic with the following composition 42P(2)O(5). 40CaO.5SrO.10Na(2)O.3TiO(2) (mol%) glass. The crystallization and sintering behavior of glass have been studied ...
Nanoindentation study of nickel manganite ceramics obtained by a complex polymerization method
(Elsevier Sci Ltd, Oxford, 2016)
The chemical synthesis of nickel manganite powder was performed by a complex polymerization method (CPM). The obtained fine nanoscaled powders were uniaxially pressed and sintered at different temperatures: 1000-1200 degrees ...
Influence of annealing treatment on magnetic properties of Fe2O3/SiO2 and formation of epsilon-Fe2O3 phase
(Ceramics International, 2017)
Magnetic properties of Fe2O3/SiO2 samples were studied after being produced by sol-gel synthesis and formation of epsilon-Fe2O3 polymorph. Samples were thermally treated, using different annealing temperatures and annealing ...
Synthesis and characterization of Cr3+ doped TiO2 nanometric powders
(Elsevier, 2016)
Simple route was used for synthesis of nanostructured titania samples doped with 3 and 6 mol% of Cr3+ Titanium(IV)-isopropoxide and water were used as starting materials and as an agents for controlling hydrolysis and ...
Synthesis and characterization of monetite and hydroxyapatite whiskers obtained by a hydrothermal method
(Elsevier Sci Ltd, Oxford, 2011)
High temperature hydrothermal syntheses, using calcium nitrate tetrahydrate, sodium dihydrogen phosphate and urea as precursors, and characterization of hydroxyapatite (HAp) whiskers are reported herein. The morphology and ...
Mechanical activation of talc in high-energy speed rotary mechanoactivator
(Elsevier LtdTechna Group S.r.l., 2012)
This paper presents the results of research on mechanical activation of raw talc in a high-energy speed rotary mechanoactivator. The results of research on effect of mechanically activated talc on the degree of recovery ...