Pretraživanje
Prikaz rezultata 11-20 od 487
Micro Nanofibrillated Cellulose as Functional Additive Supporting Processability of Surface-Active Mineral Suspensions: Exemplified by Pixel Coating of an NOx-Sorbent Layer
(MDPI, 2023)
Unlike established coating formulations, functional particulate coatings often demand the omission of polymer dispersant so as to retain surface functionality. This results in heterogeneous complex rheology. We take an ...
Influence of N doping on structural and photocatalytic properties of hydrothermally synthesized TiO2/carbon composites
(Journal of the Serbian Chemical Society, 2023)
Abstract: N-doped TiO2/carbon composites (TiO2/CN) with different nitrogen content, were obtained starting from titanium isopropoxide and glucose, and by varying the amount of melamine, added to starting reaction mixture. ...
Synthesis of Silica Particles Using Ultrasonic Spray Pyrolysis Method
(Metals, 2021)
Silica has sparked strong interest in hydrometallurgy, catalysis, the cement industry, and paper coating. The synthesis of silica particles was performed at 900 degrees C using the ultrasonic spray pyrolysis (USP) method. ...
Antimycobacterial and anticancer activity of newly designed cinnamic acid hydrazides with favorable toxicity profile: Antimycobacterial and anticancer activity of newly designed cinnamic acid
(Arabian Journal of Chemistry, 2022)
A series of twelve novel hybrids of cinnamic acid and thiocarbohydrazones were designed, synthesized in high yield using a simple coupling strategy via acid chlorides, and evaluated for their impact against Mycobacterium ...
OPTIMALITY CONDITIONS FOR ISOPERIMETRIC CONTINUOUS-TIME OPTIMIZATION PROBLEMS
(Faculty of Organizational Sciences, Belgrade, 2023)
In this paper we deal with a nonsmooth case of isoperimetric convex continuoustime programming problem with inequality integral constraint and phase constraint, defined in L∞([0, T],Rn). In order to obtain necessary ...
An Efficient Electrochemical Sensing of Caffeic Acid at Thermolysis Prepared Urea-formaldehyde Resin Modified with Fe(III) and Ti(IV) Oxide Particles
(Electrochemical Science Group, 2022)
Urea-formaldehyde resin (UF) is primarily used as an adhesive applied in the wood composites industry. In this work, we found that this resin modified with metal compounds could be a good starting point to produce ...
Radon and thoron exhalation rate measurements from building materials used in Serbia
(Nukleonika, 2020)
The second most important source of indoor radon, after soil beneath dwelling, is building material. With the increase in environmental awareness and new energy-saving policies, residents tend to replace the existing windows ...
Cavitation resistance of the material PA 3200 GF produced by selective laser sintering
(International Institute for the Science of Sintering (IISS), 2023)
The present study focuses on the results of cavitation resistance research of samples obtained by the Selective Laser Sintering technology. The samples were made from polyamide powder reinforced with glass beads – PA 3200 ...
Impact of Crosslinking on the Characteristics of Pectin Monolith Cryogels
(MDPI, 2022)
In this research, the pectin monoliths were prepared via the sol-gel process through different routes of crosslinking and additional freeze-drying. The crosslinking reaction was induced by the use of calcium ions in aqueous ...
Pipe size sensitivity in pressure relief networks using genetic algorithms
(Hemijska industrija, 2020)
This paper utilizes a stochastic optimization approach using genetic algorithms, for conducting rigorous pipe size sensitivity assessments onto the design of pressure relief networks. By sampling high performance candidates, ...