Претраживање
Приказ резултата 1-10 од 98
Influence of Cu and Mn content on the properties of Al-Mg4.5-(Mn,Cu) type alloy sheets
(Savez inženjera metalurgije Srbije, Beograd, 2009)
Influence of Cu and Mn content on the grain structure, precipitation effects and mechanical properties of two Al-Mg4.5-(Mn,Cu) type sheets was considered. It was found that a variety of grain size can be obtained in alloy ...
Cross-section analysis of the morphology of electrodeposited copper obtained in the hydrogen co-deposition range / Morfologija poprečnog preseka prevlaka bakra dobijenih elektrohemijskim taloženjem u oblasti ko-depozicije vodonika
(Serbian Chemical Society, 2009)
Cross-section analysis of copper deposits electrodeposited in the hydrogen co-deposition range at a constant overpotential and in a pulsating overpotential (PO) regime was performed. It was shown that a complete structural ...
Silver(I)-complexes with an itaconic acid-based hydrogel / Kompleksi srebra I kopolimernih hidrogelova na bazi itakonske kiseline
(Association of Chemical Engineers of Serbia, 2009)
Silver(I) itaconic acid-based hydrogel complexes were synthesized and characterized in order to examine the potential use of these systems; FTIR, AFM, in vitro fluid-uptake, metal sorption and antibacterial activity assay ...
Hydantoins: Synthesis, properties and anticonvulsant activity / Hidantoini - dobijanje, svojstva i antikonvulzivna aktivnost
(Association of Chemical Engineers of Serbia, 2009)
Hydantoin is a five-membered cyclic ureide that is present in numerous biologically active compounds including antiarrhytmics, anticonvulsants and antitumor agents. This paper describes different ways of synthesis of ...
Failure analysis of rotary screw pump / Analiza havarije rotacione vijčane pumpe
(Society for Structural Integrity and Life, Institute for Material Testing, 2009)
A case study of damage of a rotary high-pressure three screw oil hydraulic pump for regulator oil in hydroelectric power plant is presented. Results of chemical composition analysis, mechanical properties, impact energy ...
Natural resources protection by municipal solid waste recycling / Očuvanje prirodnih resursa reciklažom materijala iz komunalnog otpada
(Naučno-stručno društvo za zaštitu životne sredine Srbije - Ecologica, Beograd, 2009)
Rapid population growth, urbanization and industrial growth have led to severe waste management problems in the cities of developing countries. The improper management of municipal solid waste is a major source of air, ...
A novel bioreactor with mechanical stimulation for skeletal tissue engineering
(Association of the Chemical Engineers of Serbia, 2009)
The provision of mechanical stimulation is believed to be necessary for the functional assembly of skeletal tissues, which are normally exposed to a variety of biomechanical signals in vivo. In this paper, we present a ...
Cleaner metallurgical industry in Serbia: A road to the sustainable development
(Association of the Chemical Engineers of Serbia, 2009)
Since the sustainable development has been a global and fundamental objective, a metallurgical industrial sector faces some of the most difficult sustainability challenges of any industrial sector. On the other hand, the ...
Characterization of electrochemically synthesized PANI on graphite electrode for potential use in electrochemical power sources
(Elsevier Science Sa, Lausanne, 2009)
Polyaniline (PANI) on graphite electrode was synthesized electrochemically under galvanostatic condition at current density of 2.0 mA cm(-2) from aqueous solution of 1.0 mol dm(-3) HCl and 0.25 mol dm(-3) aniline monomer. ...
Preparation and properties of low cement castable sintered at different temperatures
(University of Novi Sad, 2009)
The low cement high alumina castable (LCC) studied in this paper was synthesised, cured and then treated at different sintering temperatures. Since any inhomogeneity introduced during the castable preparation can remain ...