Претраживање
Приказ резултата 11-20 од 23
Enhanced thermo-mechanical properties of acrylic resin reinforced with silanized alumina whiskers
(Elsevier Sci Ltd, Oxford, 2016)
The acrylic resin reinforced with silanized alumina whiskers with self-healing (SH) agents was synthesized. The self-healing system consisted of microcapsules with the healing agent dicyclopentadiene (DCPD) and modified ...
Mg/Cu co-substituted hydroxyapatite – Biocompatibility, mechanical properties and antimicrobial activity
(Elsevier Ltd, 2019)
The aim of this study was to improve the mechanical properties and to optimize antimicrobial activity of hydroxyapatite (HAP) by simultaneous doping with Mg and Cu ions in order to obtain material that would be able to ...
Bioactive glass-ceramics prepared by powder sintering and crystallization of polyphosphate glass containing strontium
(Elsevier Sci Ltd, Oxford, 2017)
Melt-quenching method was employed for obtaining a glass-ceramic with the following composition 42P(2)O(5). 40CaO.5SrO.10Na(2)O.3TiO(2) (mol%) glass. The crystallization and sintering behavior of glass have been studied ...
Mg/Cu co-substituted hydroxyapatite - Biocompatibility, mechanical properties and antimicrobial activity
(Elsevier Sci Ltd, Oxford, 2019)
The aim of this study was to improve the mechanical properties and to optimize antimicrobial activity of hydroxyapatite (HAP) by simultaneous doping with Mg and Cu ions in order to obtain material that would be able to ...
Optimized preparation of alumina based fillers for tuning composite properties
(Elsevier Sci Ltd, Oxford, 2018)
Alumina based particles were prepared from aluminium chloride hydroxide as starting material by sol-gel technique. One series of particles was doped with ferrous oxide. Both series of particles were calcinated at three ...
Shape and aspect ratio analysis of anisotropic magnetic nanochains based on TEM micrographs
(Ceramics International, 2018)
Due to advances in electron microscopy and to the development of novel nanoparticle structures with different morphologies and the dependence of physical properties on the nanoparticle morphology, there is a need for a ...
Cyclic oxidation of Ti3Al-based materials
(Ceramics International, 2019)
The microstructure variation and oxidation behavior of a hot-rolled and quenched Ti-24Al-11Nb (at%) intermetallic alloy with and without protective Ni-20Cr (at%) coating were studied in the air at a cyclic annealing ...
Influence of annealing treatment on magnetic properties of Fe2O3/SiO2 and formation of epsilon-Fe2O3 phase
(Ceramics International, 2017)
Magnetic properties of Fe2O3/SiO2 samples were studied after being produced by sol-gel synthesis and formation of epsilon-Fe2O3 polymorph. Samples were thermally treated, using different annealing temperatures and annealing ...
Change in structural, ferroelectric, and magnetic properties of bismuth ferrite induced by doping with gadolinium
(Elsevier Sci Ltd, Oxford, 2019)
Bismuth ferrite, BiFeO3, was doped with a wide range of concentrations (0-30%) of Gd in order to investigate structural, ferroelectric, and magnetic properties and their correlation. Powder samples of Bi1-xGdxFeO3 (x = ...
Nanoindentation study of nickel manganite ceramics obtained by a complex polymerization method
(Elsevier Sci Ltd, Oxford, 2016)
The chemical synthesis of nickel manganite powder was performed by a complex polymerization method (CPM). The obtained fine nanoscaled powders were uniaxially pressed and sintered at different temperatures: 1000-1200 degrees ...