Pretraživanje
Prikaz rezultata 201-210 od 210
Mean heat transfer coefficients during the evaporation of 1,1,1,2-tetrafluoroethane (R-134a) in a plate heat exchanger
(Serbian Chemical Society, 2007)
In this study the transfer coefficient of evaporation heat of the refrigerant 1,1,1,2-tetrafluoroethane (R-134a) in a vertical plate heat exchanger was experimentally investigated. The results are presented as the dependancy ...
Pressure drop during evaporation of 1,1,1,2-tetrafluoroethane (R-134a) in a plate heat exchanger
(Serbian Chemical Society, 2007)
Experimental results for the pressure drop during the evaporation of the refrigerant 1,1,1,2-tetrafluoroethane (R-134a) in a vertical plate heat exchanger are presented in Ms paper. The influences of mass flux, heat flux ...
Oxygen reduction at platinum nanoparticles supported on carbon cryogel in alkaline solution
(Srpsko hemijsko društvo, Beograd, 2007)
The oxygen reduction reaction was investigated in 0.1 M NaOH solution, on a porous coated electrode formed of Pt particles supported on carbon cryogel. The Pt/C catalyst was characterized by the X-ray diffraction (XRD), ...
Experimental and numerical evaluation of a steamline behaviour using local approach
(Croatian Metallurgical Society, 2007)
Results of the experimental and numerical comparative analysis of steamline pipes have been presented. New pipes and the pipes used for more than 117,000 hours at 540 degrees C under pressure of 42 bars have been simultaneously ...
Optimization of processing parameters for preparation of LaNiO3 thin films from the citrate precursors
(Elsevier Sci Ltd, Oxford, 2007)
Lanthanum nickel oxide (LaNiO3) is an electrically conductive ceramics, which has a potential use as electrode for ferroelectric thin films, multilayer actuators and many other electronic devices. In this work, LaNiO3 thin ...
Numerical and analytical modeling of elastic-plastic fracture mechanics parameters
(8th Conference of the Yugoslav Materials Research Society, 2007)
Structural integrity and service reliability depend on the fracture resistance of a material. Cracks in the material are the locations of stress concentration, and elastic-plastic deformation can occur causing the development ...
Crack tip strain on ship and in situ measurement in shipyards
(IFAC Proceedings Volumes (IFAC-PapersOnline), 2007)
The paper presents the application extent of procedures for measurement deformations on ships. The actual deformation distribution was measured on the surface of the specimen by the optical grating method (OGM) parallel ...
Removal of methyl tertiary butyl ether from wastewaters using photolytic, photocatalytic and microbiological degradation processes
(Elsevier Science Bv, Amsterdam, 2007)
Contamination of groundwater by methyl tertiary butyl ether (MTBE), that is detected in wastewater of petrochemical industry, is an increasing problem to water supply companies. The subjects of this research were the methods ...
Solvent and structural effects on the kinetics of the reactions of 2-substituted cyclohex-1-enylcarboxylic and 2-substituted benzoic acids with diazodiphenyl with diazodiphenylmethane
(Wiley, Hoboken, 2007)
The rate constants for the reaction of 2-methyl-cyclohex-1-enylcarboxylic, 2-phenylcyclohex-1-enylcarboxylic, and 2-methylbenzoic and 2-phenylbenzoic acids with diazodiphenyl-methane were determined in 14 various solvents ...
Investigation of antimicrobial activity of encapsulated essential oils
(8th Conference of the Yugoslav Materials Research Society, 2007)
Antimicrobial activity of essential oils obtained from many plants has been known for a long time. However, the use of essential oils as active components of biomedical textile have recently gained popularity and aroused ...