Претраживање
Приказ резултата 31-40 од 2976
Prediction of thermal shock behavior of alumina based refractories: Temperature difference, fracture resistance parameters and water quench
(Trans Tech Publications Ltd, Durnten-Zurich, 2001)
In this paper temperature difference and fracture resistance parameters were used for prediction of thermal shock behavior of the samples. Materials were alumina based commercial refractories with different content of Al2O3 ...
Osmotic coefficient of the ZnSO4(aq) at T=298.15 K
(Academic Press Ltd- Elsevier Science Ltd, London, 2002)
The osmotic coefficient of ZnSO4(aq) has been measured at T = 298.15 K by the iso-piestic method, in the range of molalities from 1.3 to 3.0 mol . kg(-1), with KCl(aq) as the reference solution. Experimental data of osmotic ...
Swelling behaviour and paracetamol release from poly(N-isopropylacrylamide-itaconic acid) hydrogels
(Springer, New York, 2009)
Copolymer hydrogels of N-isopropylacrylamide and itaconic acid (IA), crosslinked with N,N'-methylenebisacrylamide, were prepared by radical copolymerization. These hydrogels were investigated with regard to their composition ...
Synthesis and characterization of biodegradable poly(butylene succinate-co-butylene fumarate)s
(Pergamon-Elsevier Science Ltd, Oxford, 2003)
A series of aliphatic biodegradable polyesters modified with fumaric residues was synthesized by transesterification in the melt of dimethyl succinate, dimethyl fumarate and 1,4-butanediol. The amount of unsaturation, ...
Characterization of microstructural changes in an Al-6.8 wt.% Mg alloy by electrical resistivity measurements
(Elsevier Science Sa, Lausanne, 2008)
Microstructural changes in an AlMg6.8 alloy after different thermo mechanical (TMT) and sensitization treatments were investigated by electrical resistivity measurements. The electrical resistivity was most affected by the ...
Electrochemical deposition and corrosion stability of Zn-Co alloys
(Springer, New York, 2009)
Electrochemically deposited Zn-Co alloys under various deposition conditions were investigated using anodic linear sweep voltammetry for phase structure determination, scanning electron microscopy for surface morphology ...
Osmotic coefficient of the ZnCl2(aq) at T=298.15 K
(Academic Press Ltd- Elsevier Science Ltd, London, 2003)
The osmotic coefficient of ZnCl2(aq) has been measured at T = 298.15 K by the isopiestic method over the range of molalities from (0.4 to 2.4) mol . kg(-1) with KCl(aq) as the reference solution. The available literature ...
Surface characterization of keratin fibres treated by water vapour plasma
(Wiley, Hoboken, 2003)
The effect of water vapour plasma treatment on the shrinkage behaviour and chemical properties of the surface of keratin fibres was studied. The wettability and shrink resistance of wool were improved even at low plasma ...
Acceptability of Residual Stresses Measurement Methods of Butt Weldments and Repairs
(Strojarstvo, 2009)
The joints made by fusion of materials are exposed to the influence of residual stresses induced by welding thermal cycles. Residual stresses were measured on butt welded plates made of NIOMOL 490K, before and after ...
Corrosion protection of aluminium by a cataphoretic epoxy coating
(Elsevier Science Sa, Lausanne, 1999)
The corrosion behavior and thermal stability of epoxy coating electrodeposited on aluminium have been investigated during exposure to 3% NaCl. Electrochemical impedance spectroscopy (EIS), gravimetric liquid sorption ...