Претраживање
Приказ резултата 11-20 од 40
Removal of metal cations from wastewater using recycled wool-based non-woven material / Uklanjanje katjona metala iz otpadne vode netkanim materijalom na bazi vune kao sekundarne sirovine
(Serbian Chemical Society, Belgrade, 2007)
In this study, the effect of low-temperature air plasma, biopolymer chitosan and hydrogen peroxide treatment of recycled wool-based non-woven material on metal cation uptake was investigated. Recycled wool-based material ...
Cross-section analysis of the morphology of electrodeposited copper obtained in the hydrogen co-deposition range / Morfologija poprečnog preseka prevlaka bakra dobijenih elektrohemijskim taloženjem u oblasti ko-depozicije vodonika
(Serbian Chemical Society, 2009)
Cross-section analysis of copper deposits electrodeposited in the hydrogen co-deposition range at a constant overpotential and in a pulsating overpotential (PO) regime was performed. It was shown that a complete structural ...
The analysis of the tribological properties of multiple strengthened nanocomposite of the Cu-Al2o3 system
(Savez inženjera metalurgije Srbije, Beograd, 2011)
This paper presents the results of examined tribological properties of the multiple strengthened nanocomposite Cu-Al2O3 system. Cu-Al2O3 composite powder was obtained by combination of the thermo-chemical procedure and ...
Electrochemical Polymerization of Protective Polyaniline Coating on Copper
(Bor : Technical Faculty, 2011)
Paper published in 43rd International October Conference on Mining and Metallurgy - IOC 2011, October 12-15, 2011, Kladovo, Serbia: Proceedings, Bor : Technical Faculty, 2011.
Electrochemical synthesis and corrosion behavior of thin polyaniline film on mild steel, copper and aluminum / Sinteza i koroziono ponašanje polianilina na mekom čeliku, bakru i aluminijumu iz benzoatnih rastvora
(Association of Chemical Engineers of Serbia, 2011)
The electrochemical synthesis of polyaniline (PANI) on mild steel, aluminum and copper from the sodium benzoate solutions has been investigated. It has been shown that thin, highly adherent, polyaniline films on the ...
Removal of copper(II) ion from aqueous solution by high-porosity activated carbon
(Water Research Commission, Pretoria, 2013)
The removal of copper(II) ion from aqueous solution by the granular activated carbon, obtained from hazelnut shells (ACHS) (Corylus avellana L. var. lunga istriana), was investigated. The ACHS was prepared from ground dried ...
The ionic equilibrium in the CuSO4-H2SO4-H2O system and the formation of the honeycomb-like structure during copper electrodeposition / Jonska ravnoteža u sistemu CuSO4-H2SO4-H2O i formiranje strukture pčelinjeg saća elektrohemijskim taloženjem bakra
(Serbian Chemical Society, 2008)
The ionic equilibrium of the species in the CuSO4-H2SO4-H2O system was employed to systematize the conditions of copper electrodeposition leading to the formation of the honeycomb-like structure. The reason why CuSO4 ...
Treatment of waste sulfuric acid copper electrolyte / Tretman otpadnog sumporno-kiselog elektrolita bakra
(Institut za rudarstvo i metalurgiju, Bor, 2014)
The aim of this paper was to investigate the possibility of using the copper anodes with high nickel content for electrolytic treatment of waste sulfuric acid copper electrolyte. Nickel content in each anode was about 10 ...
The effect of cooling rate of slag from primary copper production in the valorization of copper in the flotation process
(Savez inženjera metalurgije Srbije, Beograd, 2015)
Technological procedure of slow cooling slag from primary copper production is applied in the purpose of copper recovery in the level of 98.5% to blister. This technological procedure is divided into two phases, first slow ...
Effect of process parameters on the phase transformation kinetics in copper-based alloys and composites
(Metallurgical & Materials Engineering, 2020)
Copper-based alloys and composites, owing to their convenient properties, are being considered essential materials in various industries. Since copper possesses an ability to develop high corrosion resistance, putting it ...