Pretraživanje
Prikaz rezultata 21-30 od 59
Cross-section analysis of the morphology of electrodeposited copper obtained in the hydrogen co-deposition range / Morfologija poprečnog preseka prevlaka bakra dobijenih elektrohemijskim taloženjem u oblasti ko-depozicije vodonika
(Serbian Chemical Society, 2009)
Cross-section analysis of copper deposits electrodeposited in the hydrogen co-deposition range at a constant overpotential and in a pulsating overpotential (PO) regime was performed. It was shown that a complete structural ...
Determination of the protective properties of electrodeposited organic epoxy coatings on aluminium and modified aluminium surfaces
(Pergamon-Elsevier Science Ltd, Oxford, 2005)
The electrochemical and transport properties and thermal stability of epoxy coatings electrodeposited on aluminium and modified aluminium surfaces (anodized, phosphatized and chromatized-phosphatized aluminium) have been ...
Epoxy coatings electrodeposited on aluminium and modified aluminium surfaces / Epoksidne kataforetske prevlake na aluminijumu i modifikovanim površinama aluminijuma
(Association of Chemical Engineers of Serbia, 2002)
The corrosion behaviour and thermal stability of epoxy coatings electrodeposited on modified aluminum surfaces (anodized, phosphatized and chromatized-phosphatized aluminium) were monitored during exposure to 3% NaCl ...
Corrosion behaviour of epoxy coatings investigated by EIS
(Trans Tech Publications Ltd, Durnten-Zurich, 1998)
Epoxy coatings were formed by cathodic electrodeposition of an epoxy resin on steel and on electrochemically modified steel surface by Fe-P alloy using constant voltage method (resin concentration 10 wt.%, temperature 26 ...
Electrophoretic deposition of thin alumina films from water suspension
(Elsevier, Amsterdam, 2002)
Alumina water suspensions have been prepared for thin alumina film deposition on steel. The type and quantity of deflocculant have been determined using zeta potential and viscosimetric measurements. The deposition was ...
The effect of hydrogen co-deposition on the morphology of copper electrodeposits. II. Correlation between the properties of electrolytic solutions and the quantity of evolved hydrogen
(Elsevier, 2008)
Formation of irregular deposits by electrodeposition from acid sulfate solutions of various H2SO4 concentrations was examined by the determination of the average current efficiency of hydrogen evolution and by the scanning ...
The electrochemical deposition and corrosion stability of Zn-Mn alloy coatings / Elektrohemijsko taloženje i koroziona stabilnost prevlaka Zn-Mn legura
(Engineering Society for Corrosion, Belgrade, Serbia, 2010)
The influence of the type of the deposition solution on the current efficiency during electrodeposition of Zn-Mn alloys was examined. The Zn-Mn alloys were deposited on steel from chloride, sulphate and pyrophosphate plating ...
Electrodeposition of silver from nitrate solution: Part II. Mechanism of the effect of phosphate ions
(Springer, Dordrecht, 1998)
The mechanism of compact Ag-film formation by electrolysis from nitrate solution with addition of small amounts of phosphate ions is elucidated. It is shown that the phosphate ions exert their effect by lowering the exchange ...
Hydrogen evolution on Ni/WC composite coatings
(Springer, 2006)
The catalytic activity for the hydrogen evolution reaction (HER) of Ni/WC composites obtained by electrochemicaldeposition of nickel from a conventional Watt’s bath, using two different ways of depositing the WC particles, ...
Impact of roughness of Zn-Mn coatings on corrosive stability / Uticaj hrapavosti Zn-Mn prevlaka na korozionu postojanost
(Engineering Society for Corrosion, Belgrade, Serbia, 2015)
This paper involves electrochemical deposition of Zn-Mn coatings from four solutions. We measured their roughness and corrosion stability. We used cathodes made of steel of unknown composition that were licensed under the ...