Претраживање
Приказ резултата 1-10 од 35
Interface shape and distribution of solute during Vertical Bridgman growth of Al-Cu alloy
(Elsevier, Amsterdam, 2002)
Results presented in this paper contribute to investigation of the influence of solidification rate (R) and the initial concentration of solute (C-o) on the interface shape and the distribution of the solute. Solidification ...
The influence of the sintering regime on the stability of the SmCo5 phase
(Elsevier, Amsterdam, 1997)
The purpose of this investigation was to establish the correlation between the sintering conditions (temperature and time) and the stability of the SmCo5 phase, expressed by the intensity of its most important diffraction ...
Influence of different iron powders on the friction properties of sintered friction materials based on iron
(Elsevier Science B.V., 2000)
The possibility of using iron powders of different morphological, chemical and physical properties as the bases of the metal matrix of the friction layer in sintered friction materials for dry friction under severe braking ...
Two-step microwave sintering-A promising technique for the processing of nanostructured bioceramics
(Elsevier Science Bv, Amsterdam, 2013)
Two-step microwave sintering was applied in this study to process dense nano-structured bioceramics coupled with improved mechanical properties. The decrease in the average grain size to the nanolevel resulting from ...
Chitosan-triclosan films for potential use as bio-antimicrobial bags in healthcare sector
(Elsevier, Amsterdam, 2017)
In this work, antimicrobial bioinspired films made from chitosan incorporated with triclosan were investigated. The tensile strenght of these films were in the range of 33 and 39 MPa, which presented satisfied mechanical ...
Bimetallic alginate nanocomposites: New antimicrobial biomaterials for biomedical application
(Elsevier Science Bv, Amsterdam, 2018)
Two bimetallic (Zn/Cu) alginate based nanocomposites, impregnated with carbonate or phosphate mineral phase, were prepared by a facile procedure. Mineralized samples exhibited different morphologies and properties when ...
Novel biosensor films based on chitosan
(Elsevier Science Bv, Amsterdam, 2016)
Films of chitosan and poly(itaconic acid) in various different ratios have been prepared by membrane casting. The enhancement in the proton conductivity and uptake of water was observed as the content of poly(itaconic acid) ...
Silicon-doped biphasic alpha-calcium-phosphate/hydroxyapatite scaffolds obtained by a replica foam method using uniform pre-annealed spherical particles
(Elsevier Science Bv, Amsterdam, 2012)
In this study, spherical particles of hydroxyapatite (HA) and alpha-tricalcium phosphate (alpha-Ca-3(PO4)(2): alpha-TCP) doped with different amounts of silicon were used for the preparation of scaffolds. The scaffolds ...
Synthesis of submicron carbon spheres by the ultrasonic spray pyrolysis method
(Elsevier, Amsterdam, 2010)
Submicron carbon spherical particles were obtained by polycondensation of resorcinol and formaldehyde in a solution and subsequent ultrasonic spray pyrolysis of the prepared sol. Microscopic characterization indicates the ...
Thermal properties of PS/TiO2 nanocomposites obtained by in situ bulk radical polymerization of styrene
(Elsevier Science Bv, Amsterdam, 2009)
TiO2 nanoparticles. surface modified with 6-palmitate ascorbic acid, were incorporated in polystyrene (PS) by in situ bulk radical polymerization of styrene using 2,2'-azobisisobutyronitrile as initiator. The molar mass ...