Претраживање
Приказ резултата 1-10 од 62
Electrodeposition of silver from nitrate solution: Part II. Mechanism of the effect of phosphate ions
(Springer, Dordrecht, 1998)
The mechanism of compact Ag-film formation by electrolysis from nitrate solution with addition of small amounts of phosphate ions is elucidated. It is shown that the phosphate ions exert their effect by lowering the exchange ...
Protective properties of epoxy coatings electrodeposited on steel electrochemically modified by Zn-Ni alloys
(Elsevier Science Sa, Lausanne, 2004)
A review is given on Zn-Ni alloys electrochemically deposited on steel under various deposition conditions. The influence of deposition current density and type of deposition solution on the chemical content, phase structure ...
Electrophoretic deposition of thin alumina films from water suspension
(Elsevier, Amsterdam, 2002)
Alumina water suspensions have been prepared for thin alumina film deposition on steel. The type and quantity of deflocculant have been determined using zeta potential and viscosimetric measurements. The deposition was ...
Hardness response and adhesion of thin copper films on alloy substrates
(Belgrade: ETRAN – Society for electronics, telecommunication, computing, automatics and nuclear engineering, 2017)
Microhardness test is the most commonly used method for assessing the mechanical properties of thin films.This testing method uses controlled contact at a single point of an indenter and chosen material which induces the ...
Corrosion behaviour of epoxy coatings electrodeposited on galvanized steel and steel modified by Zn-Ni alloys
(Elsevier Science Sa, Lausanne, 2000)
The electrochemical and transport properties and thermal stability of epoxy coatings electrodeposited on hot-dip galvanized steel and steel modified by Zn-Ni alloys were investigated during exposure to 3% NaCl solution. ...
Electrochemically deposited thin films of amorphous Fe-P alloy Part I. Chemical composition and phase structure characterization
(Elsevier Science Sa, Lausanne, 1998)
Thin Fe-P alloy films (0.5 to 25.0 mu m thick) were electrodeposited from sulfate solutions. The influences of various deposition conditions (current density, time, pH and temperature) on the composition and structure of ...
Corrosion behaviour of epoxy coatings investigated by EIS
(Trans Tech Publications Ltd, Durnten-Zurich, 1998)
Epoxy coatings were formed by cathodic electrodeposition of an epoxy resin on steel and on electrochemically modified steel surface by Fe-P alloy using constant voltage method (resin concentration 10 wt.%, temperature 26 ...
Epoxy coatings electrodeposited on aluminium and modified aluminium surfaces / Epoksidne kataforetske prevlake na aluminijumu i modifikovanim površinama aluminijuma
(Association of Chemical Engineers of Serbia, 2002)
The corrosion behaviour and thermal stability of epoxy coatings electrodeposited on modified aluminum surfaces (anodized, phosphatized and chromatized-phosphatized aluminium) were monitored during exposure to 3% NaCl ...
Epoxy coatings electrodeposited on steel electrochemically modified by Zn-Co alloys / Epoksidne kataforetske prevlake na čeliku modifikovanom Zn-Co legurama
(Engineering Society for Corrosion, Belgrade, Serbia, 2003)
The corrosion behavior of epoxy coatings electrodeposited on steel and steel modified by Zn-Co alloys deposited from chloride and sulphate baths were investigated during exposure to 3 % NaCl. The electrochemical impedance ...
The study of Zn-Co alloy coatings electrochemically deposited by pulse current / Ispitivanje prevlaka Zn-Co legura dobijenih pulsirajućom strujom
(Association of Chemical Engineers of Serbia, 2012)
The electrochemical deposition by pulse current of Zn-Co alloy coatings on steel was examined, with the aim to find out whether pulse plating could produce alloys that could offer a better corrosion protection. The influence ...