Pretraživanje
Prikaz rezultata 1-10 od 207
Mechanical features of copper coatings electrodeposited by the pulsating current (PC) regime on Si(111) substrate
(International Journal of Electrochemical Science, 2020)
Mechanical features of the Cu coatings produced by the pulsating current (PC) regime on Si(111) substrate have been investigated. The Cu coatings were electrodeposited by varying duty cycle (15-50 %) and keeping the current ...
Chemical durability of sintered glass-composite prepared from glass cullet and waste foundry sand
(Metallurgical & Materials Engineering, 2021)
In this study, the glass-composite was prepared using glass cullet and waste foundry sand as raw materials. The powder technology route was employed. The mixtures containing 10-50 wt% of the sand were sintered at T = 750 ...
FEM simulation of welded joint geometry influence on fatigue crack growth resistance
(1st Virtual European Conference on Fracture - Vecf1, 2020)
Fatigue behaviour of welded joints is investigated, in terms of welded joint geometry and the fatigue crack position. It is based on previous work which involved numerical simulation of fatigue crack growth in a welded ...
Interdisciplinary crossover for rapid advancements - collaboration between medical and engineering scientists with the focus on Serbia
(Srpski Arhiv Za Celokupno Lekarstvo, 2021)
Over the past decades, development of engineering sciences has vastly contributed to advancements in medicine by production of numerous devices for diagnostics and treatment. In the middle of the 20th century, a new ...
Hydroxyapatite/nifuroxazide conjugate: Characterization, drug release and antimicrobial activity / Хидроксиапатит/нифуроксазид конјугат: карактеризација, отпуштање лека и антимикробна активност
(Serbian Chemical Society, 2021)
Synthetic hydroxyapatite (Ca-10(PO4)(6)(OH)(2), HAp) is very similar to the inorganic part of the bones and teeth of mammals. It is a well-known biomaterial with good biocompatibility, osteoconductivity and bioactivity. ...
Technologically Sustainable Route for Metals Valorization from Jarosite-PbAg Sludge
(Minerals, 2021)
By-products from zinc hydrometallurgy are classified as hazardous waste with strong leaching toxicities. Even though numerous research papers are dedicated to valorizing valuable metals in it, the primary management route ...
Synthesis of Silica Particles Using Ultrasonic Spray Pyrolysis Method
(Metals, 2021)
Silica has sparked strong interest in hydrometallurgy, catalysis, the cement industry, and paper coating. The synthesis of silica particles was performed at 900 degrees C using the ultrasonic spray pyrolysis (USP) method. ...
Effect of the Degree of Conversion on Mechanical Properties and Monomer Elution from Self-, Dual- and Light-Cured Core Composites
(Materials, 2021)
The objective of this work was to measure and correlate the degree of conversion (DC), mechanical properties and monomer elution from self-, dual- and light-cured core composites. Five samples of each of the following ...
Radon and thoron exhalation rate measurements from building materials used in Serbia
(Nukleonika, 2020)
The second most important source of indoor radon, after soil beneath dwelling, is building material. With the increase in environmental awareness and new energy-saving policies, residents tend to replace the existing windows ...
Solvent extraction and entrainment problem
(Association of Metallurgical Engineers of Serbia, 2020)
Applications of solvent extraction operations and processes play one of the most important roles in Hydrometallurgy. Therefore, in this brief review, some general concepts for selected representative applications are ...