Search
Now showing items 1-6 of 6
A laboratory furnace for obtaining crystals
(Int Union Crystallography, Chester, 2004)
A design for a modular device ('crystallization shelf') installed in a laboratory furnace is presented. The setup allows regulation and simultaneous crystallization tests of several substances at different temperature ...
Water plus esters plus methanol: experimental data, correlation and prediction of surface and interfacial tensions at 303.15 K and atmospheric pressure
(Elsevier, Amsterdam, 2004)
For the ternary system water + ethyl propionate + methanol, and the constituent binaries, the surface tension at 303.15 K and atmospheric pressure was measured over the whole miscible composition range. The liquid interfacial ...
Spectrophotometric study of the anodic corrosion of Ti/RuO2 electrode in acid sulfate solution
(Elsevier Ltd., 2004)
Electrochemical properties of RuO2-based electrode, particularly the oxygen evolution and anodic dissolution of RuO2 have been investigated in 0.5 mol dm-3 H2SO4 solution by means of polarization measurements and product ...
Underpotential deposition of hydrogen on MoPt 4 intermetallic phase in acid solution: Temperature dependence
(Elsevier Ltd, 2004)
Potentiodynamic studies of the underpotential deposition of hydrogen (H upd ) on MoPt 4 electrode in 0.5 mol dm -3 HClO 4 aqueous solution in the range of temperature from 275 to 312 K are made and thermodynamic state ...
Microstructural investigation of the PZT films prepared from the suspension of nanocrystalline powders
(Elsevier Sci Ltd, Oxford, 2004)
PZT thin films of composition Pb(Zr0.52Ti0.48)O-3 were prepared by a novel method from the suspension of nanocrystalline PZT powders. The powders were obtained by mechanochemical synthesis. Films were deposited on silicon ...
Strontium titanate films prepared by spray pyrolysis
(Elsevier Sci Ltd, Oxford, 2004)
Strontium titanate thin films were prepared by spray pyrolysis technique. Deposition parameters, such as solution concentration, time and temperature of deposition, and flow rate of carrier gas were optimized to obtain ...