Претраживање
Приказ резултата 41-48 од 48
Shape and aspect ratio analysis of anisotropic magnetic nanochains based on TEM micrographs
(Ceramics International, 2018)
Due to advances in electron microscopy and to the development of novel nanoparticle structures with different morphologies and the dependence of physical properties on the nanoparticle morphology, there is a need for a ...
Mechanical activation of talc in high-energy speed rotary mechanoactivator
(Elsevier LtdTechna Group S.r.l., 2012)
This paper presents the results of research on mechanical activation of raw talc in a high-energy speed rotary mechanoactivator. The results of research on effect of mechanically activated talc on the degree of recovery ...
Prediction and fuzzy synthetic optimization of process parameters in heavy clay brick production
(Elsevier Sci Ltd, Oxford, 2013)
Many factors influence final clay brick properties, since the raw materials used are highly heterogeneous. Statistical analysis is rarely used, according to literature, but it would improve understanding of the overall ...
Optimized preparation of alumina based fillers for tuning composite properties
(Elsevier Sci Ltd, Oxford, 2018)
Alumina based particles were prepared from aluminium chloride hydroxide as starting material by sol-gel technique. One series of particles was doped with ferrous oxide. Both series of particles were calcinated at three ...
Nanoindentation study of nickel manganite ceramics obtained by a complex polymerization method
(Elsevier Sci Ltd, Oxford, 2016)
The chemical synthesis of nickel manganite powder was performed by a complex polymerization method (CPM). The obtained fine nanoscaled powders were uniaxially pressed and sintered at different temperatures: 1000-1200 degrees ...
Sensitivity analysis of mathematical models for final product properties: Link to DTG curve
(Elsevier Sci Ltd, Oxford, 2013)
Compressive strength and water absorption of fired heavy clay products varies with firing temperatures, but not entirely according to linear function, as it is mostly reported in literature. Also, differential thermo-gravimetric ...
Synthesis and characterization of Cr3+ doped TiO2 nanometric powders
(Elsevier, 2016)
Simple route was used for synthesis of nanostructured titania samples doped with 3 and 6 mol% of Cr3+ Titanium(IV)-isopropoxide and water were used as starting materials and as an agents for controlling hydrolysis and ...
Cyclic oxidation of Ti3Al-based materials
(Ceramics International, 2019)
The microstructure variation and oxidation behavior of a hot-rolled and quenched Ti-24Al-11Nb (at%) intermetallic alloy with and without protective Ni-20Cr (at%) coating were studied in the air at a cyclic annealing ...