Претраживање
Приказ резултата 11-20 од 24
Ni-pd/al(2)o(3) catalyst supported on reticulated ceramic foam for dry methane reforming
(Savez inženjera metalurgije Srbije, Beograd, 2015)
In the present study, Ni-Pd/Al2O3 catalyst supported on alpha-Al2O3 based foam was prepared and evaluated in the dry methane reforming process. Corresponding metal chlorides were deposited to the foam surface by impregnation ...
Treatment of dispersed iron-bearing raw materials and modeling of the protection systems against air-pollution
(Association of Metallurgical Engineers of Serbia, 2016)
Based on the analysis of the non-standard iron-bearing raw materials treatment process and the results of real composition measurements of the flue gas, the study of hazards by identification of harmful substances that ...
Laboratory testing results of kinetics and processing technology of the polymetallic sulphide concentrate Blagojev Kamen - Serbia
(Association of Metallurgical Engineers of Serbia, 2016)
This work presents the laboratory testing results of kinetics the oxidation process and sample processing of the sulphide polymetallic concentrate Blagojev Kamen. The aim of investigation is recovery of these types of raw ...
Investigation of copper(i) sulphide leaching in oxidative hydrochloric acid solution
(Savez inženjera metalurgije Srbije, Beograd, 2015)
Present work is focused on the copper (I) sulphide leaching with sodium chloride in hydrochloric acid solution and with introduction of gaseous oxygen. Chemical reactions of leaching and their thermodynamic probabilities ...
The influence of Mg and Mn content on abnormal grain growth in AA5182 type alloys
(Savez inženjera metalurgije Srbije, Beograd, 2019)
The occurrence of abnormal grain growth (AGG) in AA5182 alloy during annealing imposes severe restrictions on processing parameters and deteriorates mechanical properties. In this work, we investigated the effect of chemical ...
Defect formation during synthesis and welding of silver nanowires for solar cell applications
(Savez inženjera metalurgije Srbije, Beograd, 2019)
Structural defects such as stacking faults and twins, observed in many face-centered cubic (FCC) structured metals and alloys with low stacking fault energies, in general, play an important role in microstructure evolution, ...
Characterisation of the nanotubular oxide layer formed on the ultrafine-grained titanium
(Savez inženjera metalurgije Srbije, Beograd, 2018)
Commercially pure titanium (cpTi) and titanium alloys are metallic implant materials usually used in dentistry and orthopaedics. In order to improve implant properties, Ti-based materials may be surface modified by different ...
Optimizing the thermal gradient and the pulling speed in a thermoplastic pultrusion process of pet/e glass fibers using finite element method
(Savez inženjera metalurgije Srbije, Beograd, 2018)
A thermoplastic pultrusion process was examined using commercial fiber roving of PET/E glass, to determine the optimum pulling speed and optimal zonal temperatures. Finite element analysis predicted heat transfer through ...
Nanotubular oxide layers formed on the ti-based implants surfaces-application and possible damages: a review
(Savez inženjera metalurgije Srbije, Beograd, 2018)
Implant surface properties define the interaction of the implant with the surrounding tissue. To obtained advanced biological, mechanical and physical properties, metallic implants are often exposed to different kinds of ...
Micromechanical modelling of ductile fracture - local approach
(Savez inženjera metalurgije Srbije, Beograd, 2019)
Micromechanical modelling of ductile fracture by using the local approach has been presented as the review of previously obtained results for welded joints made of low alloyed high strength steel. Experimental work was ...