Претраживање
Приказ резултата 41-50 од 58
Change in structural, ferroelectric, and magnetic properties of bismuth ferrite induced by doping with gadolinium
(Elsevier Sci Ltd, Oxford, 2019)
Bismuth ferrite, BiFeO3, was doped with a wide range of concentrations (0-30%) of Gd in order to investigate structural, ferroelectric, and magnetic properties and their correlation. Powder samples of Bi1-xGdxFeO3 (x = ...
Nanoindentation study of nickel manganite ceramics obtained by a complex polymerization method
(Elsevier Sci Ltd, Oxford, 2016)
The chemical synthesis of nickel manganite powder was performed by a complex polymerization method (CPM). The obtained fine nanoscaled powders were uniaxially pressed and sintered at different temperatures: 1000-1200 degrees ...
Bioactive glass-ceramics prepared by powder sintering and crystallization of polyphosphate glass containing strontium
(Elsevier Sci Ltd, Oxford, 2017)
Melt-quenching method was employed for obtaining a glass-ceramic with the following composition 42P(2)O(5). 40CaO.5SrO.10Na(2)O.3TiO(2) (mol%) glass. The crystallization and sintering behavior of glass have been studied ...
Shape and aspect ratio analysis of anisotropic magnetic nanochains based on TEM micrographs
(Ceramics International, 2018)
Due to advances in electron microscopy and to the development of novel nanoparticle structures with different morphologies and the dependence of physical properties on the nanoparticle morphology, there is a need for a ...
Optimization of the production process through response surface method: Bricks made of loess
(Elsevier, 2013)
Loess clays are commonly used to produce bricks. Heavy clays, taken at location near Zrenjanin, Serbia, are used as a representative raw material in this study. The sample, containing about 28% of clay sized particles, is ...
Sensitivity analysis of mathematical models for final product properties: Link to DTG curve
(Elsevier Sci Ltd, Oxford, 2013)
Compressive strength and water absorption of fired heavy clay products varies with firing temperatures, but not entirely according to linear function, as it is mostly reported in literature. Also, differential thermo-gravimetric ...
Influence of annealing treatment on magnetic properties of Fe2O3/SiO2 and formation of epsilon-Fe2O3 phase
(Ceramics International, 2017)
Magnetic properties of Fe2O3/SiO2 samples were studied after being produced by sol-gel synthesis and formation of epsilon-Fe2O3 polymorph. Samples were thermally treated, using different annealing temperatures and annealing ...
Prediction and fuzzy synthetic optimization of process parameters in heavy clay brick production
(Elsevier Sci Ltd, Oxford, 2013)
Many factors influence final clay brick properties, since the raw materials used are highly heterogeneous. Statistical analysis is rarely used, according to literature, but it would improve understanding of the overall ...
Cyclic oxidation of Ti3Al-based materials
(Ceramics International, 2019)
The microstructure variation and oxidation behavior of a hot-rolled and quenched Ti-24Al-11Nb (at%) intermetallic alloy with and without protective Ni-20Cr (at%) coating were studied in the air at a cyclic annealing ...
Microstructure of LaNiO3 thin films obtained by the spin-on technique from citrate precursors
(Elsevier Sci Ltd, Oxford, 2008)
The morphology of perovskite LaNiO3 (LNO) thin films is a very important feature considering the fact that they could be used as an electrode material in ferroelectric devices. In this work, LNO films were prepared from ...