Претраживање
Приказ резултата 1-10 од 17
Monolithic nanocrystalline SiC ceramics
(Elsevier Sci Ltd, Oxford, 2016)
Additive-free beta-SiC nanopowders were densified by using high-pressure "anvil-type with hollows" apparatus at the pressure of 4 GPa in the range of 1500-1900 degrees C. The starting powder with average particle size of ...
Principal component analysis of morphological descriptors for monitoring surface defects induced by thermal shock
(Elsevier Ltd, 2021)
Pattern recognition techniques are applied to various morphological descriptors to monitor the formation and propagation of surface defects of materials subjected to thermal shock. A low-cement high-alumina castable was ...
Optimization of processing parameters for preparation of LaNiO3 thin films from the citrate precursors
(Elsevier Sci Ltd, Oxford, 2007)
Lanthanum nickel oxide (LaNiO3) is an electrically conductive ceramics, which has a potential use as electrode for ferroelectric thin films, multilayer actuators and many other electronic devices. In this work, LaNiO3 thin ...
Strontium titanate films prepared by spray pyrolysis
(Elsevier Sci Ltd, Oxford, 2004)
Strontium titanate thin films were prepared by spray pyrolysis technique. Deposition parameters, such as solution concentration, time and temperature of deposition, and flow rate of carrier gas were optimized to obtain ...
Microstructural investigation of the PZT films prepared from the suspension of nanocrystalline powders
(Elsevier Sci Ltd, Oxford, 2004)
PZT thin films of composition Pb(Zr0.52Ti0.48)O-3 were prepared by a novel method from the suspension of nanocrystalline PZT powders. The powders were obtained by mechanochemical synthesis. Films were deposited on silicon ...
Bioactive glass-apatite composite coating for titanium implant synthesized by electrophoretic deposition
(Elsevier Sci Ltd, Oxford, 2007)
Titanium and titanium alloys are widely used as materials for implants, because of their mechanical properties and nontoxic behaviour, but unfortunately, are bioinert. In order to solve this problem, the metal implant could ...
Principal component analysis of morphological descriptors for monitoring surface defects induced by thermal shock
(Journal of the European Ceramic Society, 2021)
Pattern recognition techniques are applied to various morphological descriptors to monitor the formation and propagation of surface defects of materials subjected to thermal shock. A low-cement high-alumina castable was ...
Nonlinear properties and stability of SnO2 varistors prepared by evaporation and decomposition of suspensions
(Elsevier Sci Ltd, Oxford, 2005)
SnO2 varistors doped with CoO, Cr2O3 and Nb2O5 were prepared by evaporation and decomposition of suspensions. The composition of the varistors was optimized to improve electrical properties, such as nonlinearity, leakage ...
Micromechanical properties of a hydroxyapatite/poly-L-lactide biocomposite using nanoindentation and modulus mapping
(Elsevier Sci Ltd, Oxford, 2007)
Biocomposites with ceramic fillers and polymer matrix are becoming attractive materials for bone tissue replacements. Nanoindentation has been used to locally characterize the surface mechanical properties of the ...
Electrical properties of cordierite obtained by non-hydrolytic sol-gel method
(Elsevier Sci Ltd, Oxford, 2007)
Cordierite ceramic material, due to its properties such as low thermal expansion coefficient, low dielectric constant and high specific resistivity, could be used as an insulating material in high-frequency electronics. ...