Претраживање
Приказ резултата 1-10 од 19
Optimization of Al2O3 particle modification and UHMWPE fiber oxidation of EVA based hybrid composites: Compatibility, morphological and mechanical properties
(Elsevier Sci Ltd, Oxford, 2018)
Ultra-high molecular weight polyethylene (UHMWPE, PE)/oxidized PE (ox-PE) fibers and alumina reinforcement were used in preparation of poly (ethylene-co-vinyl acetate) (EVA)/hydrolyzed EVA (EVAOH) based composites. Different ...
Aramid hybrid composite laminates reinforced with inorganic fullerene-like tungsten disulfide nanoparticles
(Elsevier Sci Ltd, Oxford, 2017)
Combination of phenolic resin with poly (vinyl butyral), PVB, is often used as impregnation of aramid fabrics in prepregs for the ballistic protection products. In this study an effect of inorganic fullerene-like tungsten ...
Optimized preparation of alumina based fillers for tuning composite properties
(Elsevier Sci Ltd, Oxford, 2018)
Alumina based particles were prepared from aluminium chloride hydroxide as starting material by sol-gel technique. One series of particles was doped with ferrous oxide. Both series of particles were calcinated at three ...
Composite materials from fully bio-based thermosetting resins and recycled waste poly(ethylene terephthalate)
(Elsevier Sci Ltd, Oxford, 2018)
During the last two decades, interest in bio-based polymers, especially in bio-based composite materials, has grown as a result of environmental concerns. In this paper new composites obtained from fully bio-based unsaturated ...
Mg/Cu co-substituted hydroxyapatite - Biocompatibility, mechanical properties and antimicrobial activity
(Elsevier Sci Ltd, Oxford, 2019)
The aim of this study was to improve the mechanical properties and to optimize antimicrobial activity of hydroxyapatite (HAP) by simultaneous doping with Mg and Cu ions in order to obtain material that would be able to ...
Polyurethane networks based on polycaprolactone and hyperbranched polyester: Structural, thermal and mechanical investigation
(Elsevier Science Sa, Lausanne, 2019)
A series of environmentally friendly polyurethane (PU) networks based on polycaprolactone as soft segment (SS) and Boltorn (R) aliphatic hyperbranched polyester of the second pseudo generation as crosslinking agent was ...
Initial microstructure effect on the mechanical properties of Ti-6Al-4V ELI alloy processed by high-pressure torsion
(Elsevier Science Sa, Lausanne, 2018)
effect of initial microstructure on the mechanical properties and fracture mode of the Ti-6Al-4V ELI alloy subjected to the high-pressure torsion (HPT) processing at room temperature and 500 degrees C was investigated. In ...
Nanoindentation study of nickel manganite ceramics obtained by a complex polymerization method
(Elsevier Sci Ltd, Oxford, 2016)
The chemical synthesis of nickel manganite powder was performed by a complex polymerization method (CPM). The obtained fine nanoscaled powders were uniaxially pressed and sintered at different temperatures: 1000-1200 degrees ...
The effect of mechanical activation on synthesis and properties of MgAl2O4 ceramics
(Elsevier Sci Ltd, Oxford, 2019)
Magnesium aluminate, MgAl2O4 and other alumina-based spinels are ceramics with high hardness, high melting point and mechanical strenght. Spinels can also be used as dielectrics in microwave applications. The goal of this ...
Improvement of mechanical properties and antibacterial activity of crosslinked electrospun chitosan/poly (ethylene oxide) nanofibers
(Elsevier Sci Ltd, Oxford, 2017)
In this study conditions for green crosslinking with citric acid of chitosan/PEO (polyethylene oxide) nanofibers were evaluated. The thermal in situ crosslinking enabled penetration of crosslinking agent into the matrix ...