Претраживање
Приказ резултата 1-10 од 17
Optimization of processing parameters for preparation of LaNiO3 thin films from the citrate precursors
(Elsevier Sci Ltd, Oxford, 2007)
Lanthanum nickel oxide (LaNiO3) is an electrically conductive ceramics, which has a potential use as electrode for ferroelectric thin films, multilayer actuators and many other electronic devices. In this work, LaNiO3 thin ...
Microstructural investigation of the PZT films prepared from the suspension of nanocrystalline powders
(Elsevier Sci Ltd, Oxford, 2004)
PZT thin films of composition Pb(Zr0.52Ti0.48)O-3 were prepared by a novel method from the suspension of nanocrystalline PZT powders. The powders were obtained by mechanochemical synthesis. Films were deposited on silicon ...
Strontium titanate films prepared by spray pyrolysis
(Elsevier Sci Ltd, Oxford, 2004)
Strontium titanate thin films were prepared by spray pyrolysis technique. Deposition parameters, such as solution concentration, time and temperature of deposition, and flow rate of carrier gas were optimized to obtain ...
Structural, ferroelectric and magnetic properties of BiFeO3 synthesized by sonochemically assisted hydrothermal and hydro-evaporation chemical methods
(Elsevier Sci Ltd, Oxford, 2016)
BiFeO3 powders were synthesized by sonochemically assisted hydrothermal and hydro-evaporation methods. The X-ray diffraction confirmed the presence of secondary phases, Bi25FeO39 and Bi2Fe4O9, in as prepared BiFeO3 powders. ...
The structural, electrical and optical properties of spark plasma sintered BaSn1-xSbxO3 ceramics
(Elsevier Sci Ltd, Oxford, 2020)
Antimony doped barium-stannate dense ceramic materials were synthesized using spark plasma sintering technique out of mechanically activated precursor powders. The influence of various Sb concentrations (x = 0.00 - 0.10) ...
Bioactive glass-apatite composite coating for titanium implant synthesized by electrophoretic deposition
(Elsevier Sci Ltd, Oxford, 2007)
Titanium and titanium alloys are widely used as materials for implants, because of their mechanical properties and nontoxic behaviour, but unfortunately, are bioinert. In order to solve this problem, the metal implant could ...
Assessment of viscoelastic crack bridging toughening in refractory materials
(Elsevier Sci Ltd, Oxford, 2008)
Viscoelastic bridges can be formed in refractory ceramics while cooling from high temperatures. Such bridges can shield crack tips, thus reducing the effective crack tip stress intensity factors leading to higher resistance ...
Determination of thermal shock resistance of silicon carbide/cordierite composite material using nondestructive test methods
(Elsevier Sci Ltd, Oxford, 2008)
In the present work Mg-exchanged zeolit and silicon carbide were used as starting materials for obtaining cordierite/SiC composite ceramics with weight ratio 30:70 and 50:50. Behavior of composite ceramics after thermal ...
Nonlinear properties and stability of SnO2 varistors prepared by evaporation and decomposition of suspensions
(Elsevier Sci Ltd, Oxford, 2005)
SnO2 varistors doped with CoO, Cr2O3 and Nb2O5 were prepared by evaporation and decomposition of suspensions. The composition of the varistors was optimized to improve electrical properties, such as nonlinearity, leakage ...
Principal component analysis of morphological descriptors for monitoring surface defects induced by thermal shock
(Journal of the European Ceramic Society, 2021)
Pattern recognition techniques are applied to various morphological descriptors to monitor the formation and propagation of surface defects of materials subjected to thermal shock. A low-cement high-alumina castable was ...