Претраживање
Приказ резултата 1-10 од 14
Removal of copper(II) ion from aqueous solution by high-porosity activated carbon
(Water Research Commission, Pretoria, 2013)
The removal of copper(II) ion from aqueous solution by the granular activated carbon, obtained from hazelnut shells (ACHS) (Corylus avellana L. var. lunga istriana), was investigated. The ACHS was prepared from ground dried ...
Treatment of waste sulfuric acid copper electrolyte / Tretman otpadnog sumporno-kiselog elektrolita bakra
(Institut za rudarstvo i metalurgiju, Bor, 2014)
The aim of this paper was to investigate the possibility of using the copper anodes with high nickel content for electrolytic treatment of waste sulfuric acid copper electrolyte. Nickel content in each anode was about 10 ...
Electrochemical synthesis and corrosion behavior of thin polyaniline film on mild steel, copper and aluminum / Sinteza i koroziono ponašanje polianilina na mekom čeliku, bakru i aluminijumu iz benzoatnih rastvora
(Association of Chemical Engineers of Serbia, 2011)
The electrochemical synthesis of polyaniline (PANI) on mild steel, aluminum and copper from the sodium benzoate solutions has been investigated. It has been shown that thin, highly adherent, polyaniline films on the ...
The analysis of the tribological properties of multiple strengthened nanocomposite of the Cu-Al2o3 system
(Savez inženjera metalurgije Srbije, Beograd, 2011)
This paper presents the results of examined tribological properties of the multiple strengthened nanocomposite Cu-Al2O3 system. Cu-Al2O3 composite powder was obtained by combination of the thermo-chemical procedure and ...
Electrochemical Polymerization of Protective Polyaniline Coating on Copper
(Bor : Technical Faculty, 2011)
Paper published in 43rd International October Conference on Mining and Metallurgy - IOC 2011, October 12-15, 2011, Kladovo, Serbia: Proceedings, Bor : Technical Faculty, 2011.
Sintered materials based on copper and alumina powders synthesized by a novel method
(International Institute for the Science of Sintering, Beograd, 2010)
This paper presents the production of sintered materials from nano-composite powders obtained by a novel synthesis method, which represents a combination of thermochemical synthesis and mechanical alloying. Produced powders ...
Overpotential controls the morphology of electrolytically produced copper dendritic forms / Пренапетост контролише морфологију електролитички произведених дендритичних форми бакра
(Belgrade : Serbian Chemical Society, 2019)
The morphologies of copper dendritic forms obtained in both potentiostatic and galvanostatic regimes of electrolysis with various amounts of the electricity were analyzed by the scanning electron microscopy (SEM) technique. ...
The effect of cooling rate of slag from primary copper production in the valorization of copper in the flotation process
(Savez inženjera metalurgije Srbije, Beograd, 2015)
Technological procedure of slow cooling slag from primary copper production is applied in the purpose of copper recovery in the level of 98.5% to blister. This technological procedure is divided into two phases, first slow ...
Predicting the copper adsorption capacity on different zeolites / Predviđanje adsorpcionog kapaciteta bakra na različitim zeolitima
(University of Belgrade, Technical Faculty, Bor, 2017)
In this paper the ability of three natural zeolites from different localities (Vranjska banja-VB, Igroš-I and Baia Mare-BM deposits) to remove copper has been investigated. These three zeolites were subjected to the ...
The Application of a Natural Zeolite for Acid Mine Drainage Purification
(Japan Inst Metals & Materials, Sendai, 2015)
A natural zeolite from Serbia was employed for the removal of heavy metals from acid mine drainage (AMD) generated in the area of copper mine. The efficiency of the natural zeolite samples was tested on AMD that contained ...