Pretraživanje
Prikaz rezultata 61-70 od 129
Doping of TiO2 nanotubes with nitrogen by annealing in ammonia for visible light activation: Influence of pre- and post-annealing in air
(Elsevier Science Sa, Lausanne, 2019)
The similar to 60 nm wide and similar to 2 mu m long TiO2 nanotubes were obtained by anodization of Ti films sputtered on F-doped tin oxide glass. For N-doping the samples were annealed in ammonia atmosphere. The effect ...
The influence of alumina particle modification on the adhesion of the polyacrylate matrix composite films and the metal substrate
(Taylor & Francis Ltd, Abingdon, 2019)
Adhesion behavior between the composite films, consisting of UV cured Bis-GMA (Bisphenol A glycidylmethacrylate)/TEGDMA (triethylene glycol dimethacrylate) as a matrix and the ferrous oxide doped alumina particles, Al2O3 ...
Impact of Alumina Particles on the Morphology and Mechanics of Hybrid Wood Plastic Composite Materials
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2019)
Hybrid composite panels of Wood-Plastic Composites (WPC) consisting of wood and poly (methyl methacrylate) (PMMA) were reinforced with alumina particles and made by "hot pressing" method. Alumina-based particles were made ...
Tailoring the physico-chemical and antimicrobial properties of agar-based films by in situ formation of Cu-mineral phase
(Pergamon-Elsevier Science Ltd, Oxford, 2019)
New agar-based composite films with increasing Cu-carbonate and Cu-phosphate mineral phase content were prepared by in situ mineralization and solvent casting method. SEM and optical analysis revealed that Cu-carbonate ...
Leaching of toxic elements from secondary alkaline lead slag and stabilized/solidified products
(Springer, New York, 2019)
Secondary alkaline lead slag (SALS), generated during lead-acid batteries recycling, is a hazardous waste due to its high reactivity, solubility, and migration of toxic elements. After pulverization caused by storage under ...
Recyclability of technology metals from E-waste: Case study of in and Ga recovery from magnetic fraction
(Association of Metallurgical Engineers of Serbia, 2019)
This study presents the results of the theoretical assessment and a preliminary experimental investigation of technology metals (TM) recovery from magnetic fraction obtained after mechanical treatment of waste printed ...
Adsorption performances of branched aminated waste polyacrylonitrile fibers: experimental versus modelling study
(Desalination Publ, Hopkinton, 2019)
Synthesis of branched aminated waste polyacrylonitrile (PAN) fibers, realized in a three addition/amidation successive steps, was performed in order to obtain AS3-PAN adsorbent. Influence of various operating parameters ...
Isopiestic Determination of the Osmotic and Activity Coefficients of the {yNaH(2)PO(4)+(1-y)KH2PO4}(aq) System at T=298.15K
(Springer/Plenum Publishers, New York, 2019)
Isopiestic measurements have been made for aqueous mixtures of NaH2PO4 and KH2PO4 at T=(298.15 +/- 0.01) K, at NaH2PO4 ionic strength fractions y=(0, 0.19108, 0.38306, 0.58192, and 1), assuming that both electrolytes ...
Nano-finishing of cellulose textile materials with copper and copper oxide nanoparticles
(Springer, Dordrecht, 2019)
Nano-finishing of textile materials with metal and metal oxide nanoparticles has been in the focus of science and textile industry almost two decades. The emergence of bacteria resistance to silver nanoparticles due to ...
Immobilization of Chaga extract in alginate beads for modified release: simplicity meets efficiency
(Savez hemijskih inženjera, Beograd, 2019)
Chaga (Inonotus obliquus) is a parasitic fungus, which has been used in traditional medicine in Russia and other northern European countries in the treatment of cancer, gastrointestinal andliver diseases. It has been a ...