Pretraživanje
Prikaz rezultata 1-10 od 647
Short-circuit oxygen diffusion in thermally grown silica layer
(World Scientific Publ Co Pte Ltd, Singapore, 2010)
Amorphous polymer-derived Si-C-N ceramics can be doped with different elements (Al, B etc.) through various pre-ceramic polymer routes. Thus, controlling of the high temperature oxidation resistance can be achieved on an ...
Novel composite scaffolds based on alginate and Mg-doped calcium phosphate fillers: Enhanced hydroxyapatite formation under biomimetic conditions
(Journal of Biomedical Materials Research Part B-Applied Biomaterials, 2021)
In the present study, we synthesized hydroxyapatite (HAP) powders followed by the production of alginate based macroporous scaffolds with the aim to imitate the natural bone structure. HAP powders were synthesized by using ...
Untreated wastewater impact and environmental risk assessment of artificial sweeteners in river water and sediments of the Danube River Basin in Serbia
(Springer Science and Business Media Deutschland GmbH, 2023)
Artificial sweeteners are receiving increasing attention as newly recognized emerging contaminants that mainly reach the aquatic environment through the discharge of municipal wastewater containing large amount of these ...
Synthesis and characterization of silver/poly(N-vinyl-2-pyrrolidone) hydrogel nanocomposite obtained by in situ radiolytic method
(Pergamon-Elsevier Science Ltd, Oxford, 2011)
This work describes radiolytic synthesis of silver nanoparticles (Ag NPs) within the poly(N-vinyl-2-pyrrolidone) (PVP) hydrogel. The hydrogel matrix was obtained by gamma irradiation-induced cross-linking, while the in ...
The formation of oxide nanoparticles on the surface of natural clinoptilolite
(Pergamon-Elsevier Science Ltd, Oxford, 2011)
Nanoparticles of NiO, ZnO and Cu(2)O crystallize when the Ni-, Zn- and Cu-exchanged natural clinoptilolite, respectively, are dehydrated by heating in air at 550 degrees C. The dehydration of Mn-exchanged clinoptilolite ...
Influence of picosecond laser pulses on the microstructure of austenitic materials
(Springer, New York, 2011)
We investigate samples of austenitic materials - stainless steel and iron-based superalloy - which are widely used at high temperatures and pressures. The samples were exposed to Nd(3+):YAG laser pulses with a wavelength ...
Tio2/zro2 thin films synthesized by pld in low pressure n-, c- and/or o-containing gases: structural, optical and photocatalytic properties
(Inst Materials Physics, Bucharest, 2012)
Doped TiO2/ZrO2 films were obtained by Pulsed Laser Deposition method under different synthesis conditions. The onset of absorption spectra was red shifted for the films obtained in N-2 containing gas mixtures, while a ...
Influence of the gelation and calcination temperatures on physical parameters and photocatalytic activity of mesoporous titania powders synthesized by the nonhydrolytic sol-gel process
(Elsevier, Amsterdam, 2012)
Titania powders were synthesized by nonhydrolitic sol-gel process starting from titanium(IV)-chloride, titanium(IV)-isopropoxide and carbon-tetrachloride. Gelation was performed in solvothermal conditions, at 140 degrees ...
Isopiestic determination of the osmotic and activity coefficients of the {yKNO(3) + (1-y)K2HPO4}(aq) system at T=298.15 K
(Academic Press Ltd- Elsevier Science Ltd, London, 2012)
The osmotic coefficients of aqueous mixtures of KNO3 and K2HPO4 have been measured at T = (298.15 +/- 0.01) K by the isopiestic vapor pressure method at KNO3 ionic strength fractions y = (0.20581, 0.43631, 0.61099, and ...
Modification of PET and PA fabrics with alginate and copper oxides nanoparticles
(Composite Interfaces, 2021)
The aim of this study was to fabricate novel antimicrobial nanocomposite materials by in-situ syntheses of Cu-based nanoparticles on PET and PA fabrics. The synthesis comprised three steps: (i) modification of PET and PA ...