Претраживање
Приказ резултата 21-30 од 59
Lignin-Degrading Abilities of Novel Autochthonous Fungal Isolates Trametes hirsuta F13 and Stereum gausapatum F28
(Faculty Food Technology Biotechnology, Zagreb, 2018)
The aim of this research is to isolate and identify fungi with high lignin-degrading abilities that are autochthonous to southern Serbian region. Two novel fungal isolates identified as Trametes hirsuta F13 and Stereum ...
Formation of a large-area monolayer of polystyrene film via the spin-coating method
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2018)
The self-assembly methods, an inexpensive and high throughput technique capable of producing nanostructure arrays, relies on the formation on a monolayer of self-assembled nanospheres. This paper reports on the formation ...
Sorption of textile dyes from textile wastewater by chitosan-based hydrogel / Sorpcija boja za tekstil iz tekstilnih otpadnih voda pomoću hidrogela na bazi hitozana
(Savez inženjera i tehničara Srbije, Beograd, 2018)
With the excessive risks that are present in today's environment, it is of great importance to treat wastewaters before their discharge in water streams. One of the everyday challenges is design of a low-cost and environmentally ...
Degradation of nicosulfuron using fenton and fenton-like reactions
(Savez hemijskih inženjera, Beograd, 2018)
Nicosulfuron, a sulfonylurea herbicide, was subjected to different Fenton reactions at pH of a nicosulfuron aqueous solution (pH 5). Usually, the optimal pH for the Fenton reaction is between 3 and 4, but the addition of ...
The influence of the shape and size of the AL2O3 particles on the flexural properties of the PMMA composite modified by the addition of dimethyl itaconate / Uticaj oblika i veličine čestica AL2O3 na savojna svojstva PMMA kompozita modifikovanog dodatkom dimetil itakonata
(Savez inženjera i tehničara Srbije, Beograd, 2018)
Dental materials have specific requirements regarding behavior in exploitation conditions. Poly (methyl methacrylate) (PMMA) is one of the most commonly used prosthetic materials. It is of interest to improve the mechanical ...
Microvickers hardness determination of unsaturated polyester resins reinforced with alumina based reinforcement / Ispitivanje mikrotvrdoće nezasićenih poliestarskih smola sa ojačanjima na bazi aluminijum oksida
(Savez inženjera i tehničara Srbije, Beograd, 2018)
Commercial alumina wiskers (Al2O3 w) and synthesized alumina particles via sol-gel technique (Al2O3 m) were used as reinforcement in unsaturated polyester resins (UPR). Composite materials with the addition of 0.1 wt. %, ...
Development and validation of a stability-indicating LC-UV and LC-MS/MS methods for quantitative analysis of anisomycin and identification of degradation products
(University of Sao Paulo, Conjunto Quimicas, Sao Paulo, 2018)
Multifunctional drug anisomycin was subjected to forced degradation in accordance with International Conference on Harmonisation (ICH) guidelines for the first time. The drug was exposed to the recommended stress conditions ...
Anti-tarnish silver alloys in system ag-cu-zn-si with the addition of aluminum
(Association of Metallurgical Engineers of Serbia AMES, 2018)
This paper presents investigations of aluminum addition influence on the corrosion characteristics of the sterling silver Ag-Cu-Zn-Si alloys. The procedure for obtaining Ag-Cu-Zn-Al-Si alloys in small ranges of predefined ...
Biological properties of sour cherry (Prunus cerasus L.) genotypes newly developed at Fruit Research Institute, Čačak / Biološke osobine novijih genotipova višnje (Prunus cerasus L.) stvorenih u Institutu za voćarstvo, Čačak
(Naučno voćarsko društvo Srbije, Čačak, 2018)
The work on the improvement of sour cherry (Prunus cerasus L.) genotypes at Fruit Research Institute, Čačak has been under way since 1960. The major breeding goals are to develop a self-fertile genotypes with consistent ...
The effect of calcinated hydroxyapatite and magnesium doped hydroxyapatite as fillers on the mechanical properties of a model bisgma/tegdma dental composite initially and after aging
(Savez inženjera metalurgije Srbije, Beograd, 2018)
This study aimed to investigate the possibility of modifying model BisGMA/TEGDMA dental composite by substituting 10 wt. % of conventional glass fillers with bioactive fillers based on calcinated nanosized hydroxyapatite ...