Search
Now showing items 1-10 of 121
A comparative study of chromatographic lipophilicity and bioactivity parameters of selected spirohydantoins
(Taylor & Francis Inc, Philadelphia, 2020)
In this study, lipophilicity of 21 cycloalkylspiro-5-hidantoins was assessed. The overall goal of lipophilicity evaluation is preliminary investigation which should result in a decrease of the traditionally high attrition ...
Landfill closure best available technique development: case study of Serbia
(Journal of Environmental Protection and Ecology, 2020)
Waste disposal is the last but inevitable step in waste management and it significantly effects the environment. According to the Serbian Waste Management Strategy, disposal sites should be closed and new, sanitary regional ...
Crack propagation in 3PB specimen made from welded joint
(1st Virtual European Conference on Fracture - Vecf1, 2020)
Crack propagation in 3PB specimen has been investigated experimentally by using Digital Image Correlation (DIC) technique. For this purpose, specimens were taken from butt welded plates, made of P460NL1 micro-alloyed steel. ...
Optimization of modifier deposition on the alumina surface to enhance mechanical properties and cavitation resistance
(Springer, New York, 2020)
Composites based on poly(methyl methacrylate), dimethyl itaconate matrix and alumina particles were prepared. Ferrous oxide-doped alumina particles (Al2O3Fe) and commercial alumina nanoparticles (Al(2)O(3)n) modified with ...
Electrokinetic properties of chemically modified jute fabrics / Elektrokinetička svojstva hemijski modifikovane tkanine od jute
(Serbian Chemical Society, 2020)
In this work, the electrokinetic properties of alkali and oxidatively modified jute fabrics were studied. In contrast to the control fabric, chemically modified jute fabrics had a small positive zeta potential in the basic ...
Examination of suitability of the cultivar 'Cacanska Lepotica' as a pollenizer for promising plum genotypes developed at FRI, Cacak (Serbia)
(IV Balkan Symposium on Fruit Growing, 2020)
One of the most important plum (Prunus domestica L.) breeding objectives is regular and large yield which depends on the degree of self-fertility. Partially self-fertile and self-sterile genotypes require compatible ...
Review on adhesives and surface treatments for structural applications: Recent developments on sustainability and implementation for metal and composite substrates
(MDPI, Basel, 2020)
Using adhesives for connection technology has many benefits. It is cost-efficient, fast, and allows homogeneous stress distribution between the bonded surfaces. This paper gives an overview on the current state of knowledge ...
Using scanning electron microscopy to characterise plum (prunus domestica l.) Genotypes
(Publ House Bulgarian Acad Sci, Sofia, 2020)
Pollen grain micromorphological characterisation of four plum (Prunus domestica L.) genotypes from two different breeding programmes (Fruit Research Institute, Serbia, and Hohenheim, Germany) was performed using scanning ...
Intraoral dental x-ray radiography in Bosnia and Herzegovina: study for revising diagnostic reference level value
(Oxford Univ Press, Oxford, 2020)
This paper presents the study that would allow a revision of the currently valid diagnostic reference level in intraoral dental X-ray radiography in Bosnia and Herzegovina. The study was conducted for six procedures that ...
Preparation of beechwood/polymer composites using the method of lyophilization and gamma irradiation
(Pergamon-Elsevier Science Ltd, Oxford, 2020)
Wooden cultural heritage serves as a very important source of information for historians and researchers. Also, it imposes an obligation on the science to keep this legacy for future generations in a proper condition. Among ...