Претраживање
Приказ резултата 11-17 од 17
Simulation of velocity profile inside turbulent boundary layer
(Association of Metallurgical Engineers of Serbia, 2020)
The second-order differential equation with a general polynomial solution [1], is adapted for simulation of complex velocity profile inside the turbulent boundary layer. Consequently, the simulation strategy is suggested.
Estimation of phosphorus distribution ratio at the end of blowing in bof
(Metallurgical & Materials Engineering, 2021)
In integrated steel plants, the removal of phosphorous normally takes place during the primary basic oxygen furnace (BOF) steelmaking process. Phosphorous is usually introduced to the integrated steelmaking process through ...
Cavitation resistance of basalt-based protective coatings and epoxy system
(Structural Integrity and Life-Integritet I Vek Konstrukcija, 2021)
The paper presents the results of synthesis and characterization of new refractory coatings based on basalt and epoxy system. Coatings are intended to protect the surfaces of parts of equipment and various structures in ...
Animal models in biocompatibility assessments of implants in soft and hard tissues / PRIMENA ANIMALNIH MODELA U PROCENI BIOKOMPATIBILNOSTI IMPLANTATA ZA TVRDA I MEKA TKIVA
(University of Belgrade, Faculty of Veterinary Medicine, 2022)
The ethical dilemmas of using animals as in vivo models in preclinical and clinical examinations have been increasingly present in recent decades. Small laboratory animals (rats, rabbits) will continue to be used because ...
Determination of the coffin-manson equation under low-cycle fatigue conditions
(Structural Integrity and Life-Integritet I Vek Konstrukcija, 2021)
The cycle loading of a material results in the modification of its properties and so in this paper is presented the behaviour of the fatigue life using low-cycle fatigue parameters. By applying the Coffin-Manson equation ...
Algorithm for quantifying the particle size distribution of non-metallic inclusions formation in steel production
(Metallurgical & Materials Engineering, 2021)
When the quantitative characterization of non-metallic inclusions in steel is done and the effect of limiting factors is assessed, and based on that the possibility of reconstruction of the total content of non-metallic ...
COMPARATIVE CHEMOMETRIC ANALYSIS, RANKING AND SELECTION OF LIPOPHILICITY PARAMETERS OF 6-CHLORO-1,3,5-TRIAZINE DERIVATIVES WITH ACYCLIC AND CYCLIC SUBSTITUENTS
(University of Novi Sad, Faculty of Technology, 2022)
In the present paper, the chemometric analysis, ranking and selection of the most suitable in silico lipophilicity parameters of eight alkyl and cycloalkyl s-triazine derivatives were carried out. The lipophilicity parameters ...