Претраживање
Приказ резултата 1-10 од 36
Low pressure RF capacitively coupled plasma reactor for modification of seeds, polymers and textile fabrics
(6th Conference of the Yugoslav Materials Research Society, YUCOMAT VI: Current Research in Advanced Materials and Processes, 2005)
Plasma reactor operating at low pressures (0.2-1 Torr) at 13.56 MHz has been developed with an idea to optimize the treatment of polymers, biological and textile materials. The reactor proved very effective in treatment ...
Hydrogen evolution reaction from EDTA solutions
(4th Conference of the Yugoslav Materials Research Society, 2002)
An attempt was made to investigate the mechanism and kinetics of hydrogen evolution reaction on zinc and platinum wire electrodes from solutions containing ethylene diamine tetraacetic acid (EDTA). EDTA is a tetra-basic ...
Investigation of antimicrobial activity of encapsulated essential oils
(8th Conference of the Yugoslav Materials Research Society, 2007)
Antimicrobial activity of essential oils obtained from many plants has been known for a long time. However, the use of essential oils as active components of biomedical textile have recently gained popularity and aroused ...
Numerical and analytical modeling of elastic-plastic fracture mechanics parameters
(8th Conference of the Yugoslav Materials Research Society, 2007)
Structural integrity and service reliability depend on the fracture resistance of a material. Cracks in the material are the locations of stress concentration, and elastic-plastic deformation can occur causing the development ...
Influence of Cu on the mechanical properties of an Al-4.4wt%Mg alloy after ECAP
(Trans Tech Publications, Ltd., 2006)
Two Aluminium alloys, type AA5182 and AA5182+1.2wt% Cu, have been studied. The
second alloy in solution treated condition is 18% stronger than the first one. During ageing at 150°C or 200°C it shows a characteristic fast ...
The influence of oxide sol properties on the capacitive behavior of carbon supported hydrous ruthenium oxide
(Progress in Advanced Materials and Processes: Proceedings of the Fifth Jugoslav Materials Research Society, YUCOMAT V, 2004)
Carbon supported hydrous ruthenium oxide was prepared by ail ultrasonic threatment of carbon black-RuOxHy sol mixture (impregnation). Black Pearl 2000(R) was used as a supporting material, while an oxide sol was prepared ...
Investigation on the static and fatigue failure of bi-directional composite pipes
(6th Conference of the Yugoslav Materials Research Society, YUCOMAT VI: Current Research in Advanced Materials and Processes, 2005)
The process of filament winding is particularly suited to the manufacturing of composite pipes. This paper first describes the overall process and its advantages for composite structures. Particular attention is devoted ...
Nanotribological properties of UHMWPE/quartz composites
(6th Conference of the Yugoslav Materials Research Society, YUCOMAT VI: Current Research in Advanced Materials and Processes, 2005)
Wear of ultra-high molecular weight polyethylene (UHMWPE) and its composites is one of the main obstacles that limit the longevity of total joint replacements. Compression molded UHMWPE/quartz composites with organosiloxane ...
Stress state effect on dynamic strain aging and surface markings during stretching of AlMg7 alloy sheet
(Trans Tech Publications Ltd., 1998)
Stress state effect on dynamic strain aging (DSA) and the related surface appearance was analyzed in uniaxial and biaxial room temperature stretching of AlMg7 alloy sheet. In uniaxial tension the serrated yielding was found ...
Using the image analysis program for prediction of thermal stability behavior of refractory specimen
(8th International Symposium on Multifunctional and Functionally Graded Materials, FGM2004, 2005)
Most important properties which are usually measured for refractories are work temperature and thermal stability. Thermal stability of the alumina based samples was measured using a standard laboratory procedure, the water ...