Pretraživanje
Prikaz rezultata 1-10 od 58
Nanostructured intrinsically conducting polymers formed by electrochemical synthesis / Nanostruktuirani elektroprovodni polimeri dobijeni elektrohemijskom sintezom
(Engineering Society for Corrosion, Belgrade, Serbia, 2016)
Due to unique properties of intrinsically conducting polymers (ICP) such as: electrical conductivity, reversible electrochemistry, optical activity, biocompatibility, environmental and corrosion stability, they still ...
Impact of roughness of Zn-Mn coatings on corrosive stability / Uticaj hrapavosti Zn-Mn prevlaka na korozionu postojanost
(Engineering Society for Corrosion, Belgrade, Serbia, 2015)
This paper involves electrochemical deposition of Zn-Mn coatings from four solutions. We measured their roughness and corrosion stability. We used cathodes made of steel of unknown composition that were licensed under the ...
Influence of the synthesis procedures on pt catalyst activity for ethanol electrooxidation reaction / Uticaj postupka sinteze na aktivnost platinskih katalizatora za reakciju elektrooksidacije etanola
(Engineering Society for Corrosion, Belgrade, Serbia, 2016)
Carbon supported platinum catalysts for ethanol electrooxidation were synthesized by modified polyol synthesis method, assisted by microwave or reflux heating. Synthesized catalysts were characterized by XRD, STM and TGA ...
Application of exergy analysis in recycling streams / Primena eksergijske analize u reciklažnim tokovima
(Engineering Society for Corrosion, Belgrade, Serbia, 2015)
Materials for recycling always contain a certain degree of contamination. The presence of impurities i.e. contamination in the recycling streams causes a change in the composition of the original materials to recycle. As ...
Characterization of oxide coatings formed by plasma electrolytic oxidation of aluminum in sodium tungstate / Karakterizacija oksidnih slojeva dobijenih plazma elektrolitičkom oksidacijom aluminijuma u natrijum volframatu
(Engineering Society for Corrosion, Belgrade, Serbia, 2013)
This paper presents our recent research on morphology and phase composition of oxide coatings formed by plasma electrolytic oxidation of aluminum in 0.1 M sodium tungstate at constant current density of 15 mA/cm2 and ...
Procedures for processing of copper secondary raw materials / Postupci prerade sekundarnih sirovina bakra
(Engineering Society for Corrosion, Belgrade, Serbia, 2013)
The technological procedures for copper secondary raw materials processing include two basic stages: pretreatment of the copper waste and its further metallurgical processing. For copper waste pretreatment technology, there ...
Modelling and optimization of surfactant sensor response characteristics for the use in surface water and wastewater analysis / Modelovanje i optimizovanje održivih karakteristika tenzidnog senzora za korišćenje pri analizi površinskih i otpadnih voda
(Engineering Society for Corrosion, Belgrade, Serbia, 2014)
The theoretical model of potentiometric titration curves of sodium dodecyl sulfate (anionic surfactant) was proposed and the response parameters of two surfactant sensors (commercial and self-made) were investigated. The ...
Time: Temperature superposition principle: Application of WLF equation in polymer analysis and composites / Princip superponiranja vremena i temperature - primena WLF jednačine za ispitivanje polimera i kompozita
(Engineering Society for Corrosion, Belgrade, Serbia, 2014)
Polymers are the most studied viscoelastic material. The shorter times (high frequencies) corresponding to lower temperatures and long times (low frequencies) to high temperatures. This represents the quantitatively applied ...
Influence of acidic solutions on the strain distribution in glasspolyester composite pipes subjected to internal pressure / Uticaj rastvora kiselina na raspodelu deformacija kod staklo-poliestar kompozitnih cevi istaloženih dejstvu unutrašnjeg pritiska
(Engineering Society for Corrosion, Belgrade, Serbia, 2016)
The basic subject of this paper was the determination of the strain distribution in glass-polyester composite pipes subjected to internal pressure. Firstly, the test was performed on virgin pipe segments (without the ...
Magnetic behaviour of hybrid magnetic composite materials / Magnetno ponašanje hibridnih magnetnih kompozitnih materijala
(Inženjersko društvo za koroziju, Beograd, 2014)
Polymer bonded magnets are contemporary materials with a very large range of applications. The objective of this study is to assess how different content of Nd-Fe-B and/or barium ferrite particles affect on magnetic and ...