Pretraživanje
Prikaz rezultata 41-50 od 694
Method for quantitative analysis of glycosaminoglycan distribution in cultured natural and engineered cartilage
(Amer Inst Physics, Woodbury, 1999)
Cartilage tissue engineering can provide a valuable tool for controlled studies of tissue development. As an example, analysis of the spatial distribution of glycosaminoglycans (GAG) in sections of cartilaginous tissues ...
Immobilization of lipase from Candida rugosa on a polymer support
(Springer, New York, 1998)
Lipase from Candida rugosa was immobilized by adsorption onto a macroporous copolymer support. Under optimum conditions the maximum amount of protein bound was 15.4 mg/g and the immobilization efficiency was 62%. The ...
Template effect in caesium selective phenolic resins
(Kluwer Academic Publ, Dordrecht, 1998)
Two new phenolic resins have been synthesised by alkaline polycondensation of resorcinol and acetaldehyde using template polymerisation. The extraction properties of the resins have been evaluated in competitive extraction ...
Finite element modeling of mechanical properties of particulate composite biomaterials
(Proceedings of the fourth Yugoslav Materials Research Society Conference (YUCOMAT IV), 2002)
The influence of inclusion geometry and volume fraction on stiffness behavior of a particle hydroxyapatite filled polymer (poly-L-lactide and collagen) matrix composite was investigated by finite element. analysis. The ...
Thermodynamic modeling of vapor-liquid equilibria and excess properties of the binary systems containing diethers and n-alkanes by cubic equation of state
(Korean Institute Chemical Engineers, Seoul, 2004)
A comparison of the performances of two different approaches of cubic equations of state models, based on a classical van der Waals and mixing rules incorporating the G(E) equation, was carried out for correlation of ...
Adhesion and corrosion resistance of epoxy primers used in the automotive industry
(Taylor & Francis Ltd, Abingdon, 2007)
One of the most important factors in corrosion prevention by protective coatings is the loss of adhesion of the coating under environmental influence. Thus, adhesion strength is often used when characterizing protective ...
Doped gamma-Bi2O3: synthesis of microcrystalline samples and crystal chemical analysis of structural data
(Walter de Gruyter Gmbh, Berlin, 2007)
A series of microcrystalline products containing the gamma-Bi2O3 phase doped with Co, Fe, Mn, Pb, Sb, Si, Ti, V and Zn has been prepared by solid state reaction. Based on the heating temperature and heating time, the ...
The flow of the viscous fluid around the sphere in the range Re {similar or less-than} 2
(Springer Wien, Wien, 1992)
An improved and more correct solution of Oseen's equations, when the flow of the incompressible viscous fluid around the sphere is concerned, has been suggested. The new Oseen's correction term of the Stokes solution for ...
Electrooxidation of H-2, CO and H-2/CO mixtures on a well-characterized Pt-Re bulk alloy electrode and comparison with other Pt binary alloys
(Pergamon-Elsevier Science Ltd, Oxford, 1998)
We report new results for the electrooxidation of Hz, CO and H-2/CO mixtures on a Pt75Re25 bulk alloy using surface preparation in a UHV chamber and characterization by X-ray photoelectron spectroscopy (XPS). Sputter-cleaned ...
Correlation between apparent activation energy for hot working and temperature of no recrystallization in microalloyed steels
(Trans Tech Publications Ltd, Durnten-Zurich, 2003)
Two-stage linear ln[sinh(as)] vs 1/T plots, based on the stress data derived from either continuous or multipass flow curves generated by testing low carbon Nb/Ti microalloyed steel (Nb steel) and medium carbon V-microalloyed ...