Претраживање
Приказ резултата 1-10 од 20
Synthesis of submicron carbon spheres by the ultrasonic spray pyrolysis method
(Elsevier, Amsterdam, 2010)
Submicron carbon spherical particles were obtained by polycondensation of resorcinol and formaldehyde in a solution and subsequent ultrasonic spray pyrolysis of the prepared sol. Microscopic characterization indicates the ...
Thermal properties of PS/TiO2 nanocomposites obtained by in situ bulk radical polymerization of styrene
(Elsevier Science Bv, Amsterdam, 2009)
TiO2 nanoparticles. surface modified with 6-palmitate ascorbic acid, were incorporated in polystyrene (PS) by in situ bulk radical polymerization of styrene using 2,2'-azobisisobutyronitrile as initiator. The molar mass ...
Cavitation damage of the medium carbon steel: Implementation of image analysis
(Elsevier Science Bv, Amsterdam, 2008)
Cavitation damage of the medium carbon steel was performed using the modified vibratory cavitation test set up. Erosion rates were measured by analytical method. The morphology of damage under cavitation action was determined ...
Silicon-doped biphasic alpha-calcium-phosphate/hydroxyapatite scaffolds obtained by a replica foam method using uniform pre-annealed spherical particles
(Elsevier Science Bv, Amsterdam, 2012)
In this study, spherical particles of hydroxyapatite (HA) and alpha-tricalcium phosphate (alpha-Ca-3(PO4)(2): alpha-TCP) doped with different amounts of silicon were used for the preparation of scaffolds. The scaffolds ...
Two-step microwave sintering-A promising technique for the processing of nanostructured bioceramics
(Elsevier Science Bv, Amsterdam, 2013)
Two-step microwave sintering was applied in this study to process dense nano-structured bioceramics coupled with improved mechanical properties. The decrease in the average grain size to the nanolevel resulting from ...
The implementation of image analysis for the visualization of adhesion assessment of a composite film
(Elsevier Science Bv, Amsterdam, 2018)
The objective of this study is to investigate quantitative assessment of the adhesion behavior of composite films onto a metallic surface. The composite films had UV cured Bis-GMA (Bisphenol A glycidylmethacrylate)/TEGDMA ...
The innovative combined microwave-assisted and photo-polymerization technique for synthesis of the novel degradable hydroxyethyl (meth)acrylate/gelatin based scaffolds
(Elsevier Science Bv, Amsterdam, 2018)
The discovery of novel biodegradable biomaterials able to support and control cellular activity as well as development of an enhanced and efficient method for their fabrication, are of paramount importance in the field of ...
Influence of different concentrations of Zn-carbonate phase on physical-chemical properties of antimicrobial agar composite films
(Elsevier, Amsterdam, 2019)
Agar-based composites with different Zn-carbonate mineral phase content were prepared by in situ mineralization and the solvent casting method. The mineral phase within the composite films was identified as hydrozincite, ...
Enhanced sorption of Cu2+ from sulfate solutions onto modified electric arc furnace slag
(Elsevier Science Bv, Amsterdam, 2019)
Pristine electric arc furnace slag (EAFS) as well as EAFS modified by alkali activation i.e. alkali activated slag (AAS) have found a novel application as adsorbents used in Cu2+ removal from sulfate solutions. The adsorption ...
Bimetallic alginate nanocomposites: New antimicrobial biomaterials for biomedical application
(Elsevier Science Bv, Amsterdam, 2018)
Two bimetallic (Zn/Cu) alginate based nanocomposites, impregnated with carbonate or phosphate mineral phase, were prepared by a facile procedure. Mineralized samples exhibited different morphologies and properties when ...