Pretraživanje
Prikaz rezultata 1-10 od 30
Exploitation properties of ni-pd/al2o3 catalyst supported on ceramic foam
(Savez inženjera metalurgije Srbije, Beograd, 2015)
The goal of this research was to examine exploitation properties of Ni-Pd/Al2O3 catalyst supported on alpha-Al2O3 based foam in the dry methane reforming. The catalyst was prepared by using aerosol method. Chloride precursors ...
Production of sub-micro sized silver particles by chemical reduction method in an environmentally-friendly manner
(Savez inženjera metalurgije Srbije, Beograd, 2020)
Silver nitrate in the solution was reduced in the presence of the dispersants by ascorbic acid, and silver particles were generated. The main goal was to examine the influence of different dispersants. The purpose was to ...
Micromechanical modelling of ductile fracture - local approach
(Savez inženjera metalurgije Srbije, Beograd, 2019)
Micromechanical modelling of ductile fracture by using the local approach has been presented as the review of previously obtained results for welded joints made of low alloyed high strength steel. Experimental work was ...
Anodization of Ti-based materials for biomedical applications: A review
(Association of Metallurgical Engineers of Serbia, 2016)
Commercially pure titanium (cpTi) and titanium alloys are the most commonly used metallic biomaterials. Biomedical requirements for the successful usage of metallic implant materials include their high mechanical strength, ...
Complex sulphide-barite ore leaching in ferric chloride solution
(Association of Metallurgical Engineers of Serbia, 2016)
The results of research on the leaching process of complex sulphide-barite ore were presented in this paper. The leaching process was carried out in a laboratory autoclave by ferric chloride solution. Considering that those ...
Chemical durability of sintered glass-composite prepared from glass cullet and waste foundry sand
(Metallurgical & Materials Engineering, 2021)
In this study, the glass-composite was prepared using glass cullet and waste foundry sand as raw materials. The powder technology route was employed. The mixtures containing 10-50 wt% of the sand were sintered at T = 750 ...
Solvent extraction and entrainment problem
(Association of Metallurgical Engineers of Serbia, 2020)
Applications of solvent extraction operations and processes play one of the most important roles in Hydrometallurgy. Therefore, in this brief review, some general concepts for selected representative applications are ...
Effect of process parameters on the phase transformation kinetics in copper-based alloys and composites
(Metallurgical & Materials Engineering, 2020)
Copper-based alloys and composites, owing to their convenient properties, are being considered essential materials in various industries. Since copper possesses an ability to develop high corrosion resistance, putting it ...
The effect of cooling rate of slag from primary copper production in the valorization of copper in the flotation process
(Savez inženjera metalurgije Srbije, Beograd, 2015)
Technological procedure of slow cooling slag from primary copper production is applied in the purpose of copper recovery in the level of 98.5% to blister. This technological procedure is divided into two phases, first slow ...
Treatment of dispersed iron-bearing raw materials and modeling of the protection systems against air-pollution
(Association of Metallurgical Engineers of Serbia, 2016)
Based on the analysis of the non-standard iron-bearing raw materials treatment process and the results of real composition measurements of the flue gas, the study of hazards by identification of harmful substances that ...