Претраживање
Приказ резултата 1-10 од 35
Interface shape and distribution of solute during Vertical Bridgman growth of Al-Cu alloy
(Elsevier, Amsterdam, 2002)
Results presented in this paper contribute to investigation of the influence of solidification rate (R) and the initial concentration of solute (C-o) on the interface shape and the distribution of the solute. Solidification ...
Novel biosensor films based on chitosan
(Elsevier Science Bv, Amsterdam, 2016)
Films of chitosan and poly(itaconic acid) in various different ratios have been prepared by membrane casting. The enhancement in the proton conductivity and uptake of water was observed as the content of poly(itaconic acid) ...
Synthesis of submicron carbon spheres by the ultrasonic spray pyrolysis method
(Elsevier, Amsterdam, 2010)
Submicron carbon spherical particles were obtained by polycondensation of resorcinol and formaldehyde in a solution and subsequent ultrasonic spray pyrolysis of the prepared sol. Microscopic characterization indicates the ...
Thermal properties of PS/TiO2 nanocomposites obtained by in situ bulk radical polymerization of styrene
(Elsevier Science Bv, Amsterdam, 2009)
TiO2 nanoparticles. surface modified with 6-palmitate ascorbic acid, were incorporated in polystyrene (PS) by in situ bulk radical polymerization of styrene using 2,2'-azobisisobutyronitrile as initiator. The molar mass ...
Cavitation damage of the medium carbon steel: Implementation of image analysis
(Elsevier Science Bv, Amsterdam, 2008)
Cavitation damage of the medium carbon steel was performed using the modified vibratory cavitation test set up. Erosion rates were measured by analytical method. The morphology of damage under cavitation action was determined ...
Silicon-doped biphasic alpha-calcium-phosphate/hydroxyapatite scaffolds obtained by a replica foam method using uniform pre-annealed spherical particles
(Elsevier Science Bv, Amsterdam, 2012)
In this study, spherical particles of hydroxyapatite (HA) and alpha-tricalcium phosphate (alpha-Ca-3(PO4)(2): alpha-TCP) doped with different amounts of silicon were used for the preparation of scaffolds. The scaffolds ...
Estimation of elastic properties of a particulate polymer composite using a face-centered cubic FE model
(Elsevier, Amsterdam, 2004)
A three-dimensional (31)) finite element (FE) unit cell model is applied to studies on the elastic properties of ceramic spherical particle-polymer composite. In this model, hydroxyapatite particles (HAp) are assumed to ...
Ultra-high pressure densification and properties of nanostructured SiC
(Elsevier Science Bv, Amsterdam, 2016)
Cubic SiC nano-powder particles were synthesized by a sal-gel process with an average grains size of 9.5 nm which were subsequently densified by using a high-pressure "anvil-type with hollows" apparatus at a pressure of 4 ...
Two-step microwave sintering-A promising technique for the processing of nanostructured bioceramics
(Elsevier Science Bv, Amsterdam, 2013)
Two-step microwave sintering was applied in this study to process dense nano-structured bioceramics coupled with improved mechanical properties. The decrease in the average grain size to the nanolevel resulting from ...
The implementation of image analysis for the visualization of adhesion assessment of a composite film
(Elsevier Science Bv, Amsterdam, 2018)
The objective of this study is to investigate quantitative assessment of the adhesion behavior of composite films onto a metallic surface. The composite films had UV cured Bis-GMA (Bisphenol A glycidylmethacrylate)/TEGDMA ...