Претраживање
Приказ резултата 31-40 од 49
Microencapsulation of Flavors in Carnauba Wax
(MDPI, Basel, 2010)
The subject of this study is the development of flavor wax formulations aimed for food and feed products. The melt dispersion technique was applied for the encapsulation of ethyl vanillin in wax microcapsules. The surface ...
Poly[(N-isopropylacrylamide)-co-(itaconic acid)] hydrogels with poly(ethylene glycol)
(Wiley, Hoboken, 2010)
The aim of the work reported here was to investigate temperature- and pH-sensitive hydrogels of N-isopropylacrylamide (NIPAM) and itaconic acid (IA) and their semi-interpenetrating polymer networks (semi-IPNs) with varying ...
Nb-doped TiO2 as a support of Pt and Pt-Ru anode catalyst for PEMFCs
(Elsevier Science Sa, Lausanne, 2010)
TiO2 doped by 0.5% Nb was synthesized by the acid-catalyzed sol-gel method. BET surface area was determined to be 72 m(2) g(-1). XRD measurements showed that TiO2 has structure of anatase with similar to 13 nm average ...
Synthesis of submicron carbon spheres by the ultrasonic spray pyrolysis method
(Elsevier, Amsterdam, 2010)
Submicron carbon spherical particles were obtained by polycondensation of resorcinol and formaldehyde in a solution and subsequent ultrasonic spray pyrolysis of the prepared sol. Microscopic characterization indicates the ...
Wall effects on the velocities of a single sphere settling in a stagnant and counter-current fluid and rising in a co-current fluid
(Elsevier, Amsterdam, 2010)
Experimental results were obtained on the steady settling of spheres in quiescent media in a range of cylindrical tubes to ascertain the wall effects over a relatively wide range of Reynolds number values. For practical ...
The effect of ECAP and Cu addition on the aging response and grain substructure evolution in an Al-4.4 wt.% Mg alloy
(Elsevier Science Sa, Lausanne, 2010)
The effect of ECAP conducted at 200 degrees C on the grain substructure evolution in an AA5182 alloy and the same alloy with 1.2 wt.% Cu addition was investigated. Severe plastic deformation was found to accelerate the ...
Degradation of the Insulating System of Power Transformers by Copper Sulfide Deposition: Influence of Oil Oxidation and Presence of Metal Passivator
(Amer Chemical Soc, Washington, 2010)
Deposition of conductive copper sulfide on paper insulation of power transformers was recognized as a serious risk that can result in equipment failure. The aim of this study was to investigate the influence of mineral ...
Hydrogels of N-isopropylacrylamide copolymers with controlled release of a model protein
(Elsevier Science Bv, Amsterdam, 2010)
Temperature- and pH-sensitive hydrogels, based on N-isopropylacrylamide (NiPAAm) and itaconic acid (IA), were synthesized by free radical crosslinking copolymerization in the presence of lipase from Candida rugosa. The ...
Resource recovery of animal bones: Study on sorptive properties and mechanism for Sr2+ ions
(Elsevier, 2010)
The interaction between Sr2+ ions and variously treated animal bones was studied from the aspect of Sr-90 isotope immobilization from the contaminated effluents. As a source of biogenic, poorly-crystalline apatite, bone ...
Tribological Behaviour of Orthopaedic Ti-13Nb-13Zr and Ti-6Al-4V Alloys
(Springer/Plenum Publishers, New York, 2010)
The aim of this study is to compare the tribological behaviour of novel orthopaedic implant alloy Ti-13Nb-13Zr with that of the standard Ti-6Al-4V ELI alloy, available in four different microstructural conditions produced ...