Претраживање
Приказ резултата 51-60 од 382
Numerical simulation of electrospinning process in commercial and in-house software PAK
(IOP Publishing Ltd, Bristol, 2019)
The aim of this research was to investigate if it is possible to implicitly determine the homogeneity of the obtained electrospun fibers based on jet shape during electrospinning. Experiments were performed with 10 wt% PVA ...
From titania to titanates: Phase and morphological transition in less alkaline medium under mild conditions
(Elsevier Science Sa, Lausanne, 2019)
In this work, nine products were prepared by modifying the experimental conditions (6, 12 and 18 hat 110, 135 and 160 degrees C) of hydrothermal treatment of starting nanoanatase in significantly less concentrated alkaline ...
The importance of using hydrogen evolution inhibitor during the Zn and Zn-Mn electrodeposition from ethaline
(Srpsko hemijsko društvo, Beograd, 2019)
Cyclic voltammetry was used for the characterization of zinc electro-deposition on steel from ethaline deep eutectic solution (1:2 choline chloride:ethylene glycol). The influence of 4-hydroxy-benzaldehyde (HBA) as an ...
Year of Electrochemistry
(Savez hemijskih inženjera, Beograd, 2019)
Characterisation of peppermint (Mentha piperita L.) essential oil encapsulates
(Taylor & Francis Ltd, 2019)
Aim: The aim was to choose the optimal encapsulation system and to incorporate encapsulates loaded with essential oil into the ice cream as a model food product. Methods: Ca-alginate beads were produced by electrostatic ...
Mg/Cu co-substituted hydroxyapatite – Biocompatibility, mechanical properties and antimicrobial activity
(Elsevier Ltd, 2019)
The aim of this study was to improve the mechanical properties and to optimize antimicrobial activity of hydroxyapatite (HAP) by simultaneous doping with Mg and Cu ions in order to obtain material that would be able to ...
Estimation of residual strength of a crack-containing welded pressure vessel exposed to a subzero operating temperature
(Pergamon-Elsevier Science Ltd, Oxford, 2019)
This paper presents a method for estimating the residual-strength of welded pressure vessel made of HSLA steel which contains a surface axial crack. In order to analyze the behavior of the structure, a set of specimens ...
Investigation of the dynamics of fluidized bed granulation process / Ispitivanje dinamike granulacije praškastih materijala u fluidizovanom sloju
(Serbian Chemical Society, Belgrade, 2019)
In this paper, experimental investigation of the dynamics of the process of fluidized bed granulation was performed, in order to find optimal process conditions and binder concentration to achieve the desired granules ...
The initial characteristics of the polypyrrole based aqueous rechargeable batteries with supercapattery characteristics
(Elsevier Science Bv, Amsterdam, 2019)
The electrochemically synthesized polypyrrole (PPy) is investigated as a possible active material of the low-cost aqueous based secondary power sources in combination with zinc, lead oxide, and lead sulfate. The discharge ...
Influence of Mechanical Activation of a Cordierite-Based Filler on Sedimentation Stability of Lost Foam Refractory Coatings
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2019)
For the development of the Lost Foam refractory coatings with controlled rheologic properties, the influence of the mechanical activation process on the cordierite-based filler's properties change was examined. First of ...