Претраживање
Приказ резултата 161-170 од 203
Experimental and numerical thermo - mechanical analysis of friction stir welding of high - strength alluminium alloy
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
This paper presents experimental and numerical analysis of the change of temperature and force in the vertical direction during the friction stir welding of high-strength aluminium alloy 2024 T3. This procedure confirmed ...
Analysis of the properties of a Cu-Al2-O3 sintered system based on ultra fine and nanocomposite powders
(International Institute for the Science of Sintering, Beograd, 2007)
In this paper synthesis of a composite based on Cu-Al2O3 by a thermo-chemical method is shown along with a comparative analysis of the properties of the obtained nanocomposite sintered samples, which are characterized by ...
The Mechanisms of Cavitation Erosion of Raw and Sintered Basalt
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2019)
The paper analyzes the morphology of cavitation damage of raw and sintered basalt samples. The experiment was conducted using the ultrasonic vibratory cavitation test method according to the ASTM G-32 standard. During the ...
3D Digital Image Correlation Analysis of the Shrinkage Strain in Four Dual Cure Composite Cements
(Hindawi Limited, 2019)
The introduction of resin-based cements and an adhesive-bonding system in daily dental practice has given the opportunity to increase the retention of previously conventional cemented restorations and the optimal results ...
Determination of the Load Carrying Capacity of Damaged Pipes Using Local Approach to Fracture
(Japan Inst Metals, Sendai, 2012)
The subject of this study was the application of local approach to ductile fracture in order to estimate the integrity of damaged seam casing pipes for oil and gas drilling rigs. The experimental testing included tensile ...
Influence of friction stir welding parameters on properties of 2024 t3 aluminium alloy joints
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
The aim of this work is to analyse the process of friction stir welding (FSW) of 3 mm thick aluminium plates made of high strength aluminium alloy - 2024 T3, as well as to assess the mechanical properties of the produced ...
Amino-modified kraft lignin microspheres as a support for enzyme immobilization
(Royal Society of Chemistry, 2020)
In this research, it has been demonstrated that amino-modified microspheres (A-LMS) based on bio-waste derived material, such as kraft lignin, have good prospects in usage as a support for enzyme immobilization, since ...
Consideration of a moving mass effect on dynamic behaviour of a jib crane structure
(University of Osijek, Tech Fac, Slavonski Brod, 2012)
This work examines the dynamics of a two-dimensional jib crane structure subjected to a moving trolley with hoist and payload. Dynamic responses of the structure, both in the vertical (Y) and horizontal direction (X), are ...
Dynamic Mechanical Behaviour of Polymer Bonded Nd-Fe-B Composite Materials
(Japan Inst Metals, Sendai, 2012)
Magnetic composite materials with varied content of Nd-Fe-B particles in epoxy matrix are examined from a dynamic mechanical perspective. Structural, viscoelastic and magnetic properties of composites have been observed ...
Assessing the Bioactivity of Gentamicin-Preloaded Hydroxyapatite/Chitosan Composite Coating on Titanium Substrate
(Amer Chemical Soc, Washington, 2020)
The electrophoretic deposition process (EPD) was utilized to produce bioactive hydroxyapatite/chitosan (HAP/CS) and hydroxyapatite/chitosan/gentamicin (HAP/CS/Gent) coatings on titanium. The bioactivity of newly synthesized ...