Pretraživanje
Prikaz rezultata 1-10 od 15
Novel biosensor films based on chitosan
(Elsevier Science Bv, Amsterdam, 2016)
Films of chitosan and poly(itaconic acid) in various different ratios have been prepared by membrane casting. The enhancement in the proton conductivity and uptake of water was observed as the content of poly(itaconic acid) ...
Influence of formation conditions and precursor viscosity on mean fiber diameter formed using the relating disk method
(Elsevier, Amsterdam, 2000)
Alumina ceramic fibers were produced from aluminum-hydroxidechloride based sol. Polyvinyl alcohol and surface active material were applied to adjust the rheological characteristics of the: sol. The rotating disk formation ...
Interface shape and distribution of solute during Vertical Bridgman growth of Al-Cu alloy
(Elsevier, Amsterdam, 2002)
Results presented in this paper contribute to investigation of the influence of solidification rate (R) and the initial concentration of solute (C-o) on the interface shape and the distribution of the solute. Solidification ...
Estimation of elastic properties of a particulate polymer composite using a face-centered cubic FE model
(Elsevier, Amsterdam, 2004)
A three-dimensional (31)) finite element (FE) unit cell model is applied to studies on the elastic properties of ceramic spherical particle-polymer composite. In this model, hydroxyapatite particles (HAp) are assumed to ...
Influence of different iron powders on the friction properties of sintered friction materials based on iron
(Elsevier Science B.V., 2000)
The possibility of using iron powders of different morphological, chemical and physical properties as the bases of the metal matrix of the friction layer in sintered friction materials for dry friction under severe braking ...
Ultra-high pressure densification and properties of nanostructured SiC
(Elsevier Science Bv, Amsterdam, 2016)
Cubic SiC nano-powder particles were synthesized by a sal-gel process with an average grains size of 9.5 nm which were subsequently densified by using a high-pressure "anvil-type with hollows" apparatus at a pressure of 4 ...
A facile route for hydroxyapatite densification with an increased heating rate
(Elsevier Science Bv, Amsterdam, 2017)
The densification behavior of hydroxyapatite nanorods prepared by chemical precipitation method in open reactor conditions was investigated by application of different heating rates. The non-isothermal processing was ...
Chitosan-triclosan films for potential use as bio-antimicrobial bags in healthcare sector
(Elsevier, Amsterdam, 2017)
In this work, antimicrobial bioinspired films made from chitosan incorporated with triclosan were investigated. The tensile strenght of these films were in the range of 33 and 39 MPa, which presented satisfied mechanical ...
Modification of mechanical and thermal properties of fly ash-based geopolymer by the incorporation of steel slag
(Elsevier Science Bv, Amsterdam, 2016)
Geopolymeric binders (GB) were produced using fly ash (FA) and electric arc furnace slag (EAFS). The slag has been added in the range of 0-40%. The effects of slag content on the strength, microstructure and thermal ...
Thermal shock behavior of alumina based refractories: fracture resistance parameters and water quench test
(Elsevier, Amsterdam, 1999)
The prediction of refractories thermal shock behavior can be estimated on two basis: heat transfer conditions and/or fracture mechanics concept. Materials considered in our analysis were alumina based refractories with ...