Претраживање
Приказ резултата 21-30 од 35
Influence of formation conditions and precursor viscosity on mean fiber diameter formed using the relating disk method
(Elsevier, Amsterdam, 2000)
Alumina ceramic fibers were produced from aluminum-hydroxidechloride based sol. Polyvinyl alcohol and surface active material were applied to adjust the rheological characteristics of the: sol. The rotating disk formation ...
Silicon-doped biphasic alpha-calcium-phosphate/hydroxyapatite scaffolds obtained by a replica foam method using uniform pre-annealed spherical particles
(Elsevier Science Bv, Amsterdam, 2012)
In this study, spherical particles of hydroxyapatite (HA) and alpha-tricalcium phosphate (alpha-Ca-3(PO4)(2): alpha-TCP) doped with different amounts of silicon were used for the preparation of scaffolds. The scaffolds ...
Copper nanoparticles with high antimicrobial activity
(Elsevier Science Bv, Amsterdam, 2014)
Copper (Cu) hydrosol containing small nanoparticles (NPs) (similar to 5 nm) with narrow size distribution were used to investigate antimicrobial activity toward representative microorganisms of public concern (Escherichia ...
Influence of different iron powders on the friction properties of sintered friction materials based on iron
(Elsevier Science B.V., 2000)
The possibility of using iron powders of different morphological, chemical and physical properties as the bases of the metal matrix of the friction layer in sintered friction materials for dry friction under severe braking ...
Bimetallic alginate nanocomposites: New antimicrobial biomaterials for biomedical application
(Elsevier Science Bv, Amsterdam, 2018)
Two bimetallic (Zn/Cu) alginate based nanocomposites, impregnated with carbonate or phosphate mineral phase, were prepared by a facile procedure. Mineralized samples exhibited different morphologies and properties when ...
Chitosan-triclosan films for potential use as bio-antimicrobial bags in healthcare sector
(Elsevier, Amsterdam, 2017)
In this work, antimicrobial bioinspired films made from chitosan incorporated with triclosan were investigated. The tensile strenght of these films were in the range of 33 and 39 MPa, which presented satisfied mechanical ...
Two-step microwave sintering-A promising technique for the processing of nanostructured bioceramics
(Elsevier Science Bv, Amsterdam, 2013)
Two-step microwave sintering was applied in this study to process dense nano-structured bioceramics coupled with improved mechanical properties. The decrease in the average grain size to the nanolevel resulting from ...
Quantification of deformation response at cyclic compression of polymer fibrous systems
(Elsevier Science Bv, Amsterdam, 2014)
The difficulty in qualitative evaluation of deformation properties of polymer fibrous assemblies lies in the fact that these materials differ from materials such as wood, concrete, steel, etc., as a consequence of the ...
Ultra-high pressure densification and properties of nanostructured SiC
(Elsevier Science Bv, Amsterdam, 2016)
Cubic SiC nano-powder particles were synthesized by a sal-gel process with an average grains size of 9.5 nm which were subsequently densified by using a high-pressure "anvil-type with hollows" apparatus at a pressure of 4 ...
Suitability of TiO2 nanoparticles and prolate nanospheroids for laser desorption/ionization mass spectrometric characterization of bipyridine-containing complexes
(Elsevier Science Bv, Amsterdam, 2015)
Nanostructured materials as substrates for surface-assisted laser desorption and ionization time-of-flight mass spectrometry have two main advantages such as small number of signals in the low mass range and salt tolerance. ...