Претраживање
Приказ резултата 21-30 од 30
The effect of cooling rate of slag from primary copper production in the valorization of copper in the flotation process
(Savez inženjera metalurgije Srbije, Beograd, 2015)
Technological procedure of slow cooling slag from primary copper production is applied in the purpose of copper recovery in the level of 98.5% to blister. This technological procedure is divided into two phases, first slow ...
Investigation of copper(i) sulphide leaching in oxidative hydrochloric acid solution
(Savez inženjera metalurgije Srbije, Beograd, 2015)
Present work is focused on the copper (I) sulphide leaching with sodium chloride in hydrochloric acid solution and with introduction of gaseous oxygen. Chemical reactions of leaching and their thermodynamic probabilities ...
Optimizing the thermal gradient and the pulling speed in a thermoplastic pultrusion process of pet/e glass fibers using finite element method
(Savez inženjera metalurgije Srbije, Beograd, 2018)
A thermoplastic pultrusion process was examined using commercial fiber roving of PET/E glass, to determine the optimum pulling speed and optimal zonal temperatures. Finite element analysis predicted heat transfer through ...
Characterisation of the nanotubular oxide layer formed on the ultrafine-grained titanium
(Savez inženjera metalurgije Srbije, Beograd, 2018)
Commercially pure titanium (cpTi) and titanium alloys are metallic implant materials usually used in dentistry and orthopaedics. In order to improve implant properties, Ti-based materials may be surface modified by different ...
Nanotubular oxide layers formed on the ti-based implants surfaces-application and possible damages: a review
(Savez inženjera metalurgije Srbije, Beograd, 2018)
Implant surface properties define the interaction of the implant with the surrounding tissue. To obtained advanced biological, mechanical and physical properties, metallic implants are often exposed to different kinds of ...
Micromechanical modelling of ductile fracture - local approach
(Savez inženjera metalurgije Srbije, Beograd, 2019)
Micromechanical modelling of ductile fracture by using the local approach has been presented as the review of previously obtained results for welded joints made of low alloyed high strength steel. Experimental work was ...
Anodization of Ti-based materials for biomedical applications: A review
(Association of Metallurgical Engineers of Serbia, 2016)
Commercially pure titanium (cpTi) and titanium alloys are the most commonly used metallic biomaterials. Biomedical requirements for the successful usage of metallic implant materials include their high mechanical strength, ...
Exploitation properties of ni-pd/al2o3 catalyst supported on ceramic foam
(Savez inženjera metalurgije Srbije, Beograd, 2015)
The goal of this research was to examine exploitation properties of Ni-Pd/Al2O3 catalyst supported on alpha-Al2O3 based foam in the dry methane reforming. The catalyst was prepared by using aerosol method. Chloride precursors ...
Production of sub-micro sized silver particles by chemical reduction method in an environmentally-friendly manner
(Savez inženjera metalurgije Srbije, Beograd, 2020)
Silver nitrate in the solution was reduced in the presence of the dispersants by ascorbic acid, and silver particles were generated. The main goal was to examine the influence of different dispersants. The purpose was to ...
Complex sulphide-barite ore leaching in ferric chloride solution
(Association of Metallurgical Engineers of Serbia, 2016)
The results of research on the leaching process of complex sulphide-barite ore were presented in this paper. The leaching process was carried out in a laboratory autoclave by ferric chloride solution. Considering that those ...