Претраживање
Приказ резултата 1-10 од 17
Micromechanical properties of a hydroxyapatite/poly-L-lactide biocomposite using nanoindentation and modulus mapping
(Elsevier Sci Ltd, Oxford, 2007)
Biocomposites with ceramic fillers and polymer matrix are becoming attractive materials for bone tissue replacements. Nanoindentation has been used to locally characterize the surface mechanical properties of the ...
Electrical properties of cordierite obtained by non-hydrolytic sol-gel method
(Elsevier Sci Ltd, Oxford, 2007)
Cordierite ceramic material, due to its properties such as low thermal expansion coefficient, low dielectric constant and high specific resistivity, could be used as an insulating material in high-frequency electronics. ...
Implementation of image analysis on thermal shock and cavitation resistance testing of refractory concrete
(Elsevier Sci Ltd, Oxford, 2010)
This paper presents monitoring of changes during thermal shock and cavitation testing for low cement concrete that was synthesized and sintered at 1600 degrees C for 3h. Water quench test was applied as an experimental ...
Ultra-high breakdown field varistors prepared from individually synthesized nanoprecursors
(Elsevier Sci Ltd, Oxford, 2015)
Previously synthesized nanocrystalline ZnO doped with cobalt and manganese, Bi2O3 and Sb2O3 were the precursors for high voltage varistors preparation. Varistor ceramics were sintered at 750 degrees C, 770 degrees C or 900 ...
Cavitation resistance of refractory concrete: Influence of sintering temperature
(Elsevier Sci Ltd, Oxford, 2013)
The purpose of this study was to investigate possible application of refractory concrete in conditions of cavitation effect where the metal materials are usually applied. Also, influence of different sintering temperatures ...
Monolithic nanocrystalline SiC ceramics
(Elsevier Sci Ltd, Oxford, 2016)
Additive-free beta-SiC nanopowders were densified by using high-pressure "anvil-type with hollows" apparatus at the pressure of 4 GPa in the range of 1500-1900 degrees C. The starting powder with average particle size of ...
Strontium titanate films prepared by spray pyrolysis
(Elsevier Sci Ltd, Oxford, 2004)
Strontium titanate thin films were prepared by spray pyrolysis technique. Deposition parameters, such as solution concentration, time and temperature of deposition, and flow rate of carrier gas were optimized to obtain ...
Principal component analysis of morphological descriptors for monitoring surface defects induced by thermal shock
(Elsevier Ltd, 2021)
Pattern recognition techniques are applied to various morphological descriptors to monitor the formation and propagation of surface defects of materials subjected to thermal shock. A low-cement high-alumina castable was ...
Microstructural investigation of the PZT films prepared from the suspension of nanocrystalline powders
(Elsevier Sci Ltd, Oxford, 2004)
PZT thin films of composition Pb(Zr0.52Ti0.48)O-3 were prepared by a novel method from the suspension of nanocrystalline PZT powders. The powders were obtained by mechanochemical synthesis. Films were deposited on silicon ...
Optimization of processing parameters for preparation of LaNiO3 thin films from the citrate precursors
(Elsevier Sci Ltd, Oxford, 2007)
Lanthanum nickel oxide (LaNiO3) is an electrically conductive ceramics, which has a potential use as electrode for ferroelectric thin films, multilayer actuators and many other electronic devices. In this work, LaNiO3 thin ...