Претраживање
Приказ резултата 1-10 од 13
Pd black decorated by Pt sub-monolayers as an electrocatalyst for the HCOOH oxidation
(Springer, New York, 2014)
Pd black was modified by a very low amount of Pt corresponding to a sub-monolayer (ML). Spontaneous displacement method was employed. The catalysts with 0.02-0.12 ML were characterized by cyclic voltammetry and COads ...
Morphology, internal structure and growth mechanism of electrodeposited Ni and Co powders
(Springer, New York, 2006)
In this paper the morphology (SEM analysis), the internal structure (cross-section analysis) and the growth mechanism of Ni and Co powders electrodeposited from ammoniacal electrolyte are investigated. It is shown that ...
Electrochemical deposition and characterization of iridium oxide films on Ti2AlC support for oxygen evolution reaction
(Springer, New York, 2021)
Two types of iridium oxide films formed at the Ti-2 AlC substrate were investigated: (1) anodically electrodeposited iridium oxide film from the solution based on IrCl(3)xH(2)O; (2) iridium oxide film prepared by cycling ...
Oxidation of carbon monoxide and formic acid on bulk and nanosized Pt-Co alloys
(Springer, New York, 2012)
Bulk Pt3Co and nanosized Pt3Co and PtCo alloys supported on high area carbon were investigated as the electrocatalysts for the COads and HCOOH oxidation. Pt3Co alloy with Co electrochemically leached from the surface (Pt ...
Titanium coated with high-performance nanocrystalline ruthenium oxide synthesized by the microwave-assisted sol-gel procedure
(Springer, New York, 2016)
Ruthenium oxide coating on titanium was prepared by the sol-gel procedure from well-defined colloidal oxide dispersions synthesized by the microwave (MW)-assisted hydrothermal route under defined temperature and pressure ...
Enhancement of the electrochemical reduction of oxygen at platinum by nickel underpotential deposition
(Springer, New York, 2006)
Polycrystalline Pt electrode was modified by underpotential deposition (upd) of nickel. The modification was performed by potential cycling in phosphate buffer pH 7. 0 containing NiSO4, in which hydrogen and nickel upd ...
Electrochemical deposition and corrosion stability of Zn-Co alloys
(Springer, New York, 2009)
Electrochemically deposited Zn-Co alloys under various deposition conditions were investigated using anodic linear sweep voltammetry for phase structure determination, scanning electron microscopy for surface morphology ...
Electrodeposition of Zn-Mn alloys at high current densities from chloride electrolyte
(Springer, New York, 2013)
The Zn-Mn alloy electrodeposition on a steel electrode in chloride electrolyte was investigated with the aim of obtaining deposits with as high as possible Mn percent. It was found that the deposition current density and ...
Seawater zinc/polypyrrole-air cell possessing multifunctional charge-discharge characteristics
(Springer, New York, 2017)
An environmentally friendly cell using polypyrrole-air regenerative cathode and zinc as anode is investigated in the 3% sodium chloride solution. The cell can operate in different charge and discharge mode. Polypyrrole can ...
Application of pulsating overpotential regime on the formation of copper deposits in the range of hydrogen co-deposition
(Springer, New York, 2010)
Electrodeposition of copper by pulsating overpotential (PO) regime in the range of hydrogen co-deposition was examined by scanning electron microscopy. It was found that the increase of the pause-to-pulse ratio produced a ...