Search
Now showing items 1-10 of 49
Impact of choice of stabilized hysteresis loop on the end result of investigation of high-strength low-alloy (hsla) steel on low cycle fatigue
(Croatian Metallurgical Soc, Zagreb, 2014)
High strength low-alloy steel under low cycle fatigue at a certain level of strain controlled achieve stabilized condition. During the fatigue loading stabilized hysteresis loop is determined, which typical cycle of ...
Effect of surface modified TiO2 nanoparticles on thermal, barrier and mechanical properties of long oil alkyd resin-based coatings
(Budapest Univ Technol & Econ, Budapest, 2015)
Novel soy alkyd-based nanocomposites (NCs) were prepared using TiO2 nanoparticles (NPs) surface modified with different gallates, and for the first time with imine obtained from 3,4-dihydroxybenzaldehyde and oleylamine ...
Identification of low cycle fatigue parameters of high strength low-alloy (hsla) steel at room temperature
(Croatian Metallurgical Soc, Zagreb, 2014)
Low cycle fatigue test was performed in ambient atmosphere at room temperature. cycle loading of material, in case of High strength low-alloy steel, entails modifications of its properties and in this paper is therefore ...
An Investigation into Mechanical Properties and Printability of Potential Substrates for Inkjet Printing of Orodispersible Films
(Pharmaceutics, 2021)
Inkjet printing is novel approach in drug manufacturing that enables dispensing precise volumes of ink onto substrates. Optimal substrate properties including suitable mechanical characteristic are recognized as crucial ...
Microstructure and properties of silver based cadmium free electrical contact materials
(University of Belgrade, Technical Faculty, Bor, 2007)
The presented work covers part of experimental results of simultaneous study of microstructure, density, hardness and electrical conductivity of sintered electrical contact materials based of Ag- SnO2 with 8, 10 and 12 ...
Smart hydrogels based on itaconic acid for biomedical application / Inteligentni hidrogelovi na bazi itakonske kiseline za biomedicinsku primenu
(Association of Chemical Engineers of Serbia, 2009)
pH and temperature sensitive hydrogels, based on 2-hydroxyethyl methacrylate (HEMA) and itaconic acid (IA) copolymers, were prepared by gamma irradiation and characterized in order to examine their potential use in biomedical ...
The use of image analysis for the study of interfacial bonding in solid composite propellant / Korišćenje analize slike za određivanje interakcija u čvrstim kompozitnim gorivima
(Serbian Chemical Society, Belgrade, 2007)
In the framework of this research, the program Image Pro Plus was applied for determining the polymer-oxidizer interactions in HTPB-based composite propellants. In order to improve the interactions, different bonding agents ...
Preparation and properties of low cement castable sintered at different temperatures
(University of Novi Sad, 2009)
The low cement high alumina castable (LCC) studied in this paper was synthesised, cured and then treated at different sintering temperatures. Since any inhomogeneity introduced during the castable preparation can remain ...
Influence of heat treatment on mechanical and sorptional properties of viscose-based nonwovens
(Niscair, 2005)
The influence of heat treatment on sorptional and mechanical properties of viscose: polypropylene (90:10) blend nonwoven fleeces has been studied. It is observed that the heat treatment improves mechanical properties ...
Effect of the Degree of Conversion on Mechanical Properties and Monomer Elution from Self-, Dual- and Light-Cured Core Composites
(Materials, 2021)
The objective of this work was to measure and correlate the degree of conversion (DC), mechanical properties and monomer elution from self-, dual- and light-cured core composites. Five samples of each of the following ...