Pretraživanje
Prikaz rezultata 21-30 od 39
New composites based on waste PET and non-metallic fraction from waste printed circuit boards: Mechanical and thermal properties
(Elsevier Sci Ltd, Oxford, 2017)
Influence of the addition of three different non-metallic fractions (NMF), obtained by processing of printed circuit boards (PCBs), on the mechanical and thermal properties of unsaturated polyester resin (UPR) based ...
Optimized preparation of alumina based fillers for tuning composite properties
(Elsevier Sci Ltd, Oxford, 2018)
Alumina based particles were prepared from aluminium chloride hydroxide as starting material by sol-gel technique. One series of particles was doped with ferrous oxide. Both series of particles were calcinated at three ...
Mg/Cu co-substituted hydroxyapatite - Biocompatibility, mechanical properties and antimicrobial activity
(Elsevier Sci Ltd, Oxford, 2019)
The aim of this study was to improve the mechanical properties and to optimize antimicrobial activity of hydroxyapatite (HAP) by simultaneous doping with Mg and Cu ions in order to obtain material that would be able to ...
Composite materials from fully bio-based thermosetting resins and recycled waste poly(ethylene terephthalate)
(Elsevier Sci Ltd, Oxford, 2018)
During the last two decades, interest in bio-based polymers, especially in bio-based composite materials, has grown as a result of environmental concerns. In this paper new composites obtained from fully bio-based unsaturated ...
Effects of dispersion and particle-matrix interactions on mechanical and thermal properties of hnt/epoxy nanocomposite materials
(International Conference on New Technologies, Development and Application, NT 2020, 2021)
Halloysite nanotubes (HNTs), naturally occurring as aluminosilicate nanoclay mineral, have recently emerged as a possible nanomaterial for countless applications due to their specific chemical structure, tubular shape, ...
Nanoindentation study of nickel manganite ceramics obtained by a complex polymerization method
(Elsevier Sci Ltd, Oxford, 2016)
The chemical synthesis of nickel manganite powder was performed by a complex polymerization method (CPM). The obtained fine nanoscaled powders were uniaxially pressed and sintered at different temperatures: 1000-1200 degrees ...
Biocomposite membranes of highly methylated pectin and mesoporous silica SBA-15
(Elsevier Ltd., 2014)
Manufacturing of synthetic composites consumes huge energy and their disposal at the end of the life cycle is very difficult since there is virtually no recycling option. Therefore, biocomposite materials have recently ...
Effect of mechanical activation on carbothermal synthesis and densification of ZrC
(Elsevier Ltd, 2023)
Zirconium carbide ceramics were prepared by carbothermal reduction of ZrO2 and C that were mixed by high-energy ball milling. Powders were milled for times from 0 to 120 min in air. As milling time increased, the surface ...
Initial microstructure effect on the mechanical properties of Ti-6Al-4V ELI alloy processed by high-pressure torsion
(Elsevier Science Sa, Lausanne, 2018)
effect of initial microstructure on the mechanical properties and fracture mode of the Ti-6Al-4V ELI alloy subjected to the high-pressure torsion (HPT) processing at room temperature and 500 degrees C was investigated. In ...
Tailoring the properties of waterborne polyurethanes by incorporating different content of poly(dimethylsiloxane)
(Progress in Organic Coatings, 2021)
A series of novel waterborne polyurethanes (WBPUs) was synthesized using alpha,omega-dihydroxypropyl poly(dimethylsiloxane) (PDMS), isophorone diisocyanate (IPDI), 2,2-bis-(hydroxymethyl) propionic acid (DMPA) and triethylamine ...