Претраживање
Приказ резултата 11-20 од 35
Cavitation damage of the medium carbon steel: Implementation of image analysis
(Elsevier Science Bv, Amsterdam, 2008)
Cavitation damage of the medium carbon steel was performed using the modified vibratory cavitation test set up. Erosion rates were measured by analytical method. The morphology of damage under cavitation action was determined ...
Synthesis of submicron carbon spheres by the ultrasonic spray pyrolysis method
(Elsevier, Amsterdam, 2010)
Submicron carbon spherical particles were obtained by polycondensation of resorcinol and formaldehyde in a solution and subsequent ultrasonic spray pyrolysis of the prepared sol. Microscopic characterization indicates the ...
Influence of formation conditions and precursor viscosity on mean fiber diameter formed using the relating disk method
(Elsevier, Amsterdam, 2000)
Alumina ceramic fibers were produced from aluminum-hydroxidechloride based sol. Polyvinyl alcohol and surface active material were applied to adjust the rheological characteristics of the: sol. The rotating disk formation ...
Interface shape and distribution of solute during Vertical Bridgman growth of Al-Cu alloy
(Elsevier, Amsterdam, 2002)
Results presented in this paper contribute to investigation of the influence of solidification rate (R) and the initial concentration of solute (C-o) on the interface shape and the distribution of the solute. Solidification ...
Novel biosensor films based on chitosan
(Elsevier Science Bv, Amsterdam, 2016)
Films of chitosan and poly(itaconic acid) in various different ratios have been prepared by membrane casting. The enhancement in the proton conductivity and uptake of water was observed as the content of poly(itaconic acid) ...
Thermal properties of PS/TiO2 nanocomposites obtained by in situ bulk radical polymerization of styrene
(Elsevier Science Bv, Amsterdam, 2009)
TiO2 nanoparticles. surface modified with 6-palmitate ascorbic acid, were incorporated in polystyrene (PS) by in situ bulk radical polymerization of styrene using 2,2'-azobisisobutyronitrile as initiator. The molar mass ...
Silicon-doped biphasic alpha-calcium-phosphate/hydroxyapatite scaffolds obtained by a replica foam method using uniform pre-annealed spherical particles
(Elsevier Science Bv, Amsterdam, 2012)
In this study, spherical particles of hydroxyapatite (HA) and alpha-tricalcium phosphate (alpha-Ca-3(PO4)(2): alpha-TCP) doped with different amounts of silicon were used for the preparation of scaffolds. The scaffolds ...
Structural and optical characterization of hemimorphite with flower-like morphology synthesized by a novel low-temperature method
(Materials Letters, 2012)
We report on novel, low temperature synthesis of well crystallized hemimorphite zinc silicate Zn4Si2O7(OH)(2)(H2O) (ZSO) with flower-like morphology, via one-pot method that includes the assistance of a non-ionic block ...
Structural analysis of abrasive composite materials with nonwoven textile matrix
(Elsevier B.V., 2004)
The goal of this research was to design the novel composite material based on nonwoven textile material (NTM) while using the existing production facilities. The chosen product was abrasive composite material with nonwoven ...
Mechanochemically induced amorphous/crystalline phase transition in the Bi4Ti3O12 compound
(Elsevier, 2009)
Concurrent milling of Bi4Ti3O12 was carried out in a planetary ball mill with hardened-steel 13 or 6 mm diameter balls with a goal to investigate how the system responds to the constrains imposed by milling. Milling intensity ...