Претраживање
Приказ резултата 1-10 од 42
One-step synthesis of NIR-responsive NaYF4:Yb,Er"Chitosane nanoparticles for biomedical application
(Belgrade : Institute of Physics Belgrade, 2017)
There is a great technological interest in synthesis of lanthanide doped upconverting nanoparticles with specific morphological characteristics and efficient luminescence response suitable for biomedical use [1]. A ...
Fractographic analysis of biomedical Ti-based alloys with acicular microstructures
(Ruđer Bošković Institute and Croatian Microscopy Society, 2017)
Hardness response and adhesion of thin copper films on alloy substrates
(Belgrade: ETRAN – Society for electronics, telecommunication, computing, automatics and nuclear engineering, 2017)
Microhardness test is the most commonly used method for assessing the mechanical properties of thin films.This testing method uses controlled contact at a single point of an indenter and chosen material which induces the ...
In-vitro visualization of primary tumor cells using up-conversion nanophosphors
(Belgrade : Serbian Ceramic Society, 2017)
For such purpose, Ln-UCNPs should have specific morphological characteristics and efficient luminescence response. In this work, a biocompatible and water dispersible NaYF4:Yb,Er"PLGA nanoparticles synthesized using a ...
Technological analysis for machining of the reformers for fuel cells testing
(Innovation Center of Faculty of Mechanical Engineering, 2017)
Reformer is an integral component of the polymeric electrolyte membrane (PEM) fuel cell and it is used for
experimental combustion testing. By analyzing the geometry of the experimental reformer, it consists of three
plates, ...
Designing of manufacturing process of reformer integrated in system with HTPEM fuel cell stack
(Belgrade : Faculty of Mechanical Engineering, Innovation Center, 2017)
In this paper is shown designing of manufacturing process of reformer in polymeric electrolyte membrane
(PEM) fuel cell. The process is based on reformer modelling, analyzing of reforming initial geometry and
change of ...
Comparison of possible improvements of a periodically operated adiabatic CSTR with inlet concentration modulation for different shapes of the forcing function
(10th World Congress of Chemical Engineering (WCCE10), Barcelona, Spain, 2017)
Deliberate periodic operations have been recognized as one way of process intensification for several decades. Special attention has been dedicated to possible improvements of chemical reactor performance through periodic ...
Fabrication and applications of multifunctional nanostructured TiO2
(Belgrade : Faculty of Agriculture, Department for Agricultural Engineering, 2017)
Nanomaterials development is a rapidly emerging field of research with enormous potential for societal and economic benefits. In agro and food industries dimension-dependent properties or phenomena of nanomaterials may be ...
The effect of galacto-oligosaccharides on growth and viability of probiotic bacteria in fermented whey based bevereage
(UDRUŽENJE MIKROBIOLOGA SRBIJE, 2017)
Galacto-oligosaccharides (GOS) are produced from milk lactose during transgalactosylation reaction using -galactosidase. Depending on reaction condition, -galactosidase can, also, hydrolyse lactose, in order to make ...
Creep crack growth - Comparison of two steel P91 and P22
(14th International Conference on Fracture, ICF 2017, 2017)
The deformation and crack growth behaviour of P22 and P91 steel weldments tested at 550 °C and 600 °C, respectively,compact C(T) type specimens with sharp EDM starter notches in the base metal (BM) and heat affected zone ...