Pretraživanje
Prikaz rezultata 1-10 od 818
Laboratory authorization versus accreditation in transitional economies: Case study of Serbia
(Springer New York, 2006)
Many CEE governments are still using various systems of laboratory authorization together with ISO/IEC 17025 laboratory accreditation. It is difficult to understand from the EU prospective, the existence of two parallel ...
Electrocatalytic properties of surface oxides on gold, platinum, and stainless steel electrodes in electrooxidation of malic acid
(Maik Nauka-Interperiodica Publishing, 2005)
Electrocatalytic properties of oxides formed at gold, platinum, and stainless steel electrodes in the malic acid electrooxidation in 0.1 M Na 2 SO 4 are studied. Gas chromatographic analysis of the electrolyte after holding ...
Synthesis and single-crystal structure analysis of a new layered zinc phosphate
(Pure and Applied Chemistry, 2005)
A new 2D zinc phosphate [H3NCH(CH3)CH 2NH3]2+0.75[COOH(CH 2)COOH]0.25 (Zn3P3O 11OH)2-* 0.5NH4+ consists of zinc phosphate layers, which are intercalated by diprotonated 1,2-diaminopropane, malonic acid, and NH4+ ions. The ...
Characterization of carbon cryogel synthesized by sol-gel polycondensation and freeze-drying
(Carbon, 2004)
Resorcinol-formaldehyde (RF) cryogels were synthesized by sol-gel polycondensation of resorcinol with formaldehyde and freeze-drying was carried out with t-butanol. Carbon cryogels were obtained by pyrolyzing RF cryogels ...
Treatment of heavy metals contaminated solid wastes-Stabilization
(4th European Metallurgical Conference, EMC 2007, 2007)
This paper presents investigation of possibility of heavy metals contaminated solid wastes treatment form Bor Site, Serbia. Presented remediation technology is stabilization, which can effectively reduce content of ...
Reflection and structural analyses of mirror-bright metal coatings
(Springer, 2004)
Reflection and structural analyses of different copper and zinc coatings were performed. The copper coatings were electrodeposited from a sulfate solution in the presence of thiourea, as well as in the presence of modified ...
Optimization of processing parameters for preparation of LaNiO3 thin films from the citrate precursors
(Elsevier Sci Ltd, Oxford, 2007)
Lanthanum nickel oxide (LaNiO3) is an electrically conductive ceramics, which has a potential use as electrode for ferroelectric thin films, multilayer actuators and many other electronic devices. In this work, LaNiO3 thin ...
Damage Level Estimate of API J55 Steel for Welded Seam Casing Pipes
(Strojarstvo, 2009)
The subject of this paper is investigation of the damage level of API J55 steel, used for manufacturing casing pipes by high frequency (HF) contact welding. The analysed pipe was withdrawn after about 70 000 hours of service ...
Formation of nanocrystalline transition-metal ferrites inside a silica matrix
(Wiley, Hoboken, 2002)
Nanocrystalline transition-metal ferrites were synthesized inside an amorphous silica matrix by the sol-gel method. The formation of spinel ferrites began above 400degreesC, giving fine particles of about 10 nm at 800degreesC. ...
SmartMetals: a new method for metal identification based on fuzzy logic
(John Wiley & Sons Ltd, Chichester, 2009)
This paper presents a method of searching, identifying and cross-referencing metal alloys based on their chemical composition and/or mechanical properties, typically obtained by analysis and tests. The method uses a general ...