Search
Now showing items 11-20 of 23
Ex-situ sensitization of ordered TiO2 nanotubes with CdS quantum dots
(Elsevier Sci Ltd, Oxford, 2015)
Ordered titania nanotubes (pore diameter approximate to 90 nm and wall thickness approximate to 10 nm) were obtained by the anodization technique and used for the ex-situ deposition of cadmium sulfide quantum dots (CdS ...
Mg/Cu co-substituted hydroxyapatite - Biocompatibility, mechanical properties and antimicrobial activity
(Elsevier Sci Ltd, Oxford, 2019)
The aim of this study was to improve the mechanical properties and to optimize antimicrobial activity of hydroxyapatite (HAP) by simultaneous doping with Mg and Cu ions in order to obtain material that would be able to ...
Comparative study of CeO2 nanopowders obtained by the hydrothermal method from various precursors
(Elsevier Sci Ltd, Oxford, 2015)
The effects of common precursors used in the synthesis of CeO2 nanopowders were investigated, and the structural and spectral properties of the resulting products were compared. Two cerium (III) salts, i.e., Ce(NO3)(3)center ...
Optimized preparation of alumina based fillers for tuning composite properties
(Elsevier Sci Ltd, Oxford, 2018)
Alumina based particles were prepared from aluminium chloride hydroxide as starting material by sol-gel technique. One series of particles was doped with ferrous oxide. Both series of particles were calcinated at three ...
Sr,Mg co-doping of calcium hydroxyapatite: Hydrothermal synthesis, processing, characterization and possible application as dentin substitutes
(Ceramics International, 2022)
The aim of this study was to investigate the influence of binary Sr, Mg ion-doping compared to the single-ion doping effects on the phase composition and morphology of hydrothermally obtained calcium hydroxyapatite (HAP) ...
Supporting information for the article: Vujančević, J., Andričević, P., Bjelajac, A., Đokić, V., Popović, M., Rakočević, Z., Horváth, E., Kollár, M., Náfrádi, B., Schiller, A., Domanski, K., Forró, L., Pavlović, V., Janaćković, Đ., 2019. Dry-pressed anodized titania nanotube/CH3NH3PbI3 single crystal heterojunctions: The beneficial role of N doping. Ceramics International 45, 10013–10020. https://doi.org/10.1016/j.ceramint.2019.02.045
(Ceramics International, 2019)
Table S1. Reported methods for nitrogen doping of anodized TiO2 nanotube arrays; Figure S1. SEM images and statistical distributions of outer diameters obtained by analyzing SEM micrographs of 100 nanotubes; Table S2. ...
Dry-pressed anodized titania nanotube/CH3NH3PbI3 single crystal heterojunctions: The beneficial role of N doping
(Elsevier Sci Ltd, Oxford, 2019)
Highly ordered, anodically grown TiO2 nanotubes on titanium supports were annealed in ammonia atmosphere in order to incorporate nitrogen doping ( lt = 2 at.%) in the titanium oxide lattice. FESEM micrographs revealed ...
Structural and morphological characterization of iron-doped sol-gel derived mullite powders
(Elsevier Sci Ltd, Oxford, 2020)
The structural and morphological properties of iron-doped mullite powders are the subject of the present study. The powders of undoped and iron-doped mullite in the composition range of 3-15 wt% Fe2O3 were synthesized by ...
Effect of YAG content on creep resistance and mechanical properties of Al2O3-YAG composite
(Elsevier Sci Ltd, Oxford, 2020)
Comprehensive study on effect of YAG amount on densification, creep resistance and room-temperature mechanical properties of Al2O3-YAG composite pressureless sintered at 1600 degrees C was conducted. The main goal was to ...
Mechanical properties and thermal shock resistance of anorthite ceramics obtained by slip casting
(Elsevier Ltd., 2024)
Anorthite ceramics (CaAl2Si2O8) was obtained by slip casting of water suspension of kaolin (Al2O3·2SiO2·2H2O) and CaCO3 as a source of CaO. A relative density of 87 % of the theoretical density was achieved after a 3-h-long ...