Претраживање
Приказ резултата 11-20 од 43
Anisotropy Analysis of Low Cement Concrete by Ultrasonic Measurements and Image Analysis
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2016)
The analized material was high alumina low cement castable sintered at three different temperatures. Influence of initial material anisotropy on the thermal shock resistance as well as changes of anisotropy level during ...
Evolution of Structural and Functional Properties of the Fe/BaTiO3 System Guided by Mechanochemical and Thermal Treatment
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2020)
Multiferroic systems are attractive to the researches worldwide due to diversity of existing applications, as well as possible novel ones. In order to contribute to understanding of the processes that take place within the ...
Sintered materials based on copper and alumina powders synthesized by a novel method
(International Institute for the Science of Sintering, Beograd, 2010)
This paper presents the production of sintered materials from nano-composite powders obtained by a novel synthesis method, which represents a combination of thermochemical synthesis and mechanical alloying. Produced powders ...
Investigation of Possibility for Stabilization and Valorization of Electric Arc Furnace Dust and Glass From Electronic Waste
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2014)
This paper presents investigation of possibility for electric arc furnace dust (EAFD) and electronic waste (e-waste) valorization trough stabilization process, in order to achieve concurrent management of these two serious ...
Adsorption of Anthraquinone Dye AB111 from Aqueous Solution using Synthesized Alumina-Iron Oxide Doped Particles
(Science of Sintering, 2021)
Adsorption of anthraquinone dye Acid Blue 111 by alumina-iron oxide doped particles prepared by sol-gel method from aqueous solutions was studied. The adsorbent morphology was revealed by FESEM and the crystallographic ...
Influence of Mechanical Activation of a Cordierite-Based Filler on Sedimentation Stability of Lost Foam Refractory Coatings
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2019)
For the development of the Lost Foam refractory coatings with controlled rheologic properties, the influence of the mechanical activation process on the cordierite-based filler's properties change was examined. First of ...
Structure and Microstructure Characterization of the La2SrB10O19 Glass-ceramics
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2019)
The crystal structure of new lanthanum strontium borate glass-ceramics was refined by the Rietveld method. The results showed that La2SrB10O19 has the monoclinic crystal structure, space group C2 (No. 5) with a = 11.1170(6), ...
Comparison of Morphological Parameters of Ceramic Materials Surface Damage Exposed to Thermal Shock and Cavitation Erosion
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2016)
The surface defects on the samples, which are based on alumina, exposed to thermal shocks and cavitations erosion were analyzed using image analysis. For both types of experimental testing, the samples are made of the same ...
The Influence of Barium Ferrite Nanoparticles on Morphological and Mechanical Properties of Ethyl Cellulose Based Nanocomposites
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2019)
This study presents preparation and characterization of ethyl cellulose based nanocomposites. Successful use of simple solvent casting technique provided nanocomposites with high loads of barium ferrite magnetic nanopowder ...
Photocatalytic Degradation of Bisphenol A with alpha-Fe2O3 Fibers and Particles
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2019)
Two-step synthesis of Fe2O3 particles, performed by precipitation from iron(III) chloride (FeCl3 center dot 6H(2)O) using ammonium hydroxide in first step and calcination at 400 and 700 degrees C during 4 h, provided Fe2O3 ...