Pretraživanje
Prikaz rezultata 41-50 od 75
The effect of K2O on the crystallization of niobium germanate glasses
(International Institute for the Science of Sintering, Beograd, 2011)
The effect of K2O content on the crystallization of niobium germanate glasses with 22.7- 24.27 wt% of GeO2 and 54.59-57.48 wt% of Nb2O5 was examined. The glasses crystallize by primary crystallization and the formed ...
Non-Isothermal Crystallization of Lithium Germanophosphate Glass Studied by Different Kinetic Methods
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2018)
Crystallization kinetics of 22.5Li(2)O center dot 10Al(2)O(3)center dot 30GeO(2)center dot 37.5P(2)O(5) (mol%) glass was studied under non-isothermal condition using the differential thermal analysis (DTA). The study was ...
Comparison of Morphological Parameters of Ceramic Materials Surface Damage Exposed to Thermal Shock and Cavitation Erosion
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2016)
The surface defects on the samples, which are based on alumina, exposed to thermal shocks and cavitations erosion were analyzed using image analysis. For both types of experimental testing, the samples are made of the same ...
The Influence of Barium Ferrite Nanoparticles on Morphological and Mechanical Properties of Ethyl Cellulose Based Nanocomposites
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2019)
This study presents preparation and characterization of ethyl cellulose based nanocomposites. Successful use of simple solvent casting technique provided nanocomposites with high loads of barium ferrite magnetic nanopowder ...
Influence of Temperature and Different Hydroxides on Properties of Activated Carbon Prepared From Saccharose. Characterization, Thermal Degradation Kinetic and Dyes Removal From Water Solutions
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2018)
In presented paper, influence of temperature, precursor concentration and different hydroxides on properties of activated carbon obtained from saccharose were investigated. The samples were prepared by hydrothermal treatment ...
Improving the Packaging Performance of Low-Density Polyethylene With PCL/Nanocellulose/Copper(II)Oxide Barrier Layer
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2018)
A novel double layered hybrid materials, consisting of low density polyethylene (LDPE) base layer and polycaprolactone (PCL) top layer containing surface modified nanocellulose (NC) based nanocomposites in 0.5 and 2% ...
Characterization of Neodymium Doped Calcium Tungstate Single Crystal by Raman, IR and Luminescence Spectroscopy
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2018)
The aim of the current work was to assess obtain a single crystal of calcium tungstate doped with neodymium - (CaWO4:Nd3+), and after that, the crystal was characterized with various spectroscopic methods. The single crystal ...
TiO2 nanotubes film/FTO glass interface: Thermal treatment effects
(ETRAN, 2022)
Pure Ti films deposited by radio-frequency magnetron sputtering on FTO glass were anodized to fabricate TiO2 nanotubes (NTs) arrays. The TiO2 NTs/FTO samples were sintered at 450, 550 and 630°C, in ambient air. The thermal ...
Basalt-Polyester Hybrid Composite Materials for Demanding Wear Applications
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2020)
Basalt as a filler in a polymer-based composite material fulfils the demand of being natural, environment-friendly material for the production of various composite materials. The material could be used as protective layer ...
Evaluation of Adsorption Performance and Quantum Chemical Modeling of Pesticides Removal using Cell-MG Hybrid Adsorbent
(Science of Sintering, 2021)
Magnetite (MG) modified cellulose membrane (Cell-MG), obtained by reaction of 3-aminosilane and subsequently with diethylenetriaminepentaacetic acid dianhydride functionalized waste Cell fibers (Cell-NH2 and Cell-DTPA, ...